Navnet TZ 2 touch Installation Checklist - Dff3 Mode Switch Settings
of
8
If you have more than one network sounder in the system, please contact Furuno Tech
Support for setup information.
Only change
settings for S2.
Do not change
settings for S3.
The DFF3 is defaulted to work with NavNet 3D MFDs. If you are connecting the DFF3
to an original NavNet 1, vx2, TZtouch or TZtouch2 only network, you need to change
the MODE switches as shown below.
If the DFF3 will be installed in a mixed system comprised of a NavNet 3D MFD8,
MFD12 or MFDBB and either of the TZtouch displays, the DIP Switches must remain
in the default settings shown below.
Default settings
for NavNet 3D
Alternate settings for NavNet 1,
vx2, TZtouch & TZtouch2
7
DFF3 MODE Switch Settings
Connection to NavNet 1, vx2, 3D, TZtouch & TZtouch2