Navtex NVX-1000 Safety & Operating Instructions Manual - page 6
Page
6
A) Cable connection
1.
Connect the monitor to the camera with the cable according to the wiring diagram.
2.
Carefully insert the wires to the terminal by pressing down the terminal flap with any small
tool taking care that the 2 bare wires do not touch.
Distance between the Panel and the
Monitor
Type of cable to use
From 1 to 25 Meters
Two 6/10º wires
Up to 100 meters
Two 1.5 mm2 wires
B) Installation height
1. Recommended installation heightis approximately 140cm for monitor unit and 150cm for
outdoor camera.
C) Installation of indoor monitor
1. Fix the wall mounting bracket in the best place by using 4 screws and plugs.
2. Carefully place the indoor monitor against the bracket and gently push down the monitor so that
the pins on the bracket engage in the slots on the rear of the monitor.
3. Setting the Master and Slave monitor:
1 MONITOR SETUP
Status Switch 1
Status Switch 2
#
#
ON (top)
ON (top)
2 MONITORES SETUP
Monitor
Status Switch 1
Status Switch 2
#
Master
ON (top)
ON (top)
Slave
OFF (down)
OFF (down)