Navtex NVX-1000 Safety & Operating Instructions Manual - page 7
Page
7
IMPORTANT !
Depending upon the installation (1 or 2 viedo monitors) the position of the dip-switches on
The back of each video monitor must be set correctly (see table below)
Any changes to the position of the dip-swiches on either the main or optinal video monitor
Will require the power suply to be disconnected for 30 seconds and then reconnected
Operating Instructions
1. Activation of Units
When the call button on the outside camera unit is pressed, the indoor unit chime rings and the visitor’s
picture will appear on the indoor monitor. After the visitor is visually identified, and you wish to talk with
the visitor, touch the
Talk On icon. The unit will remain activated for approximately40 seconds
before it automatically shuts off. To re-activate for continued conversation, touch the
Camera 1/ 2
icon.
2. Activation of outside unit from monitor unit
a) Touch the
Camera 1/2 icon of the indoor unit at any time and the main outdoor camera will
be activated and show the outside view.
b) If you have installed two outdoor panel cameras, press the
Camera 1/2 icon to change from
camera one to another. Once initiated, conversation can be made from selected outdoor panel to indoor
monitor. To manually shut off touch the
Talk On icon.
3. Working time
a) Call time: Approximately 40 seconds
The picture terminates automatically if indoor unit is not answered within approximately 40
seconds after the call button of the outdoor camera unit is pressed.
b) Talk time: Approximately 80 seconds
When monitor unit is called by the outdoor unit and the monitor is answered, there is
approximately 80 seconds of time available before the unit automatically shuts off.
c) Monitor time: Approximately 40 seconds
When outside camera is activated from the inside, there is approximately 40 seconds of viewing
time before the unit automatically shuts off.
4. Activation of (“Intercom” Function)
When the monitor is in standby mode touch the
Talk On/Off icon on the indoor monitor, monitor
rings with intercom call sound. Another monitor will ring with intercom calling. touch the
Talk
On/Off icon on other monitor to initiate conversation among monitors. Touch the
Talk On/Off