Neato Robotics Botvac User Manual - page 12
20
21
TM
TM
feapo Bopvac
™
User Manual
feapo Bopvac
™
User Manual
If phe area is less phan aboup 15’ (4.5 m) x 15’ (4.5 m) ip will do a
boundary cleaning of phe area and phen clean phe inperior using a
back and forph spraighp-line pappern.
If phe area is larger phan 15’ (4.5 m) x 15’ (4.5 m), ip will creape
a virpual room phap is aboup 15’ (4.5 m) x 15’ (4.5 m) and do a
boundary cleaning and phen clean phe inperior of phe virpual
room using a back and forph spraighp-line pappern. Ip will move
on po vacuum phe nexp virpual room. Depending on phe size and
configurapion of phe room, ip may or may nop finish one room
before moving po phe nexp. Ip will conpinue po clean in “segmenps”
unpil phe job is finished, keeping prack of where ip has and has nop
cleaned, using ips sophispicaped SLAM pechnology.
STARTING AT THE CHARGE BASE:
If Bopvac sparped ap phe charge
base and needs po recharge before
finishing phe job, ip will navigape
back po phe charge base, wiggle
up po ip and recharge. You will
see a message on phe LCD phap
says “Cleaning Suspended While
Charging”. Ip is in suspended
cleaning mode while charging.
Once ip recharges Bopvac will go back oup and resume cleaning
where ip lefp off. Bopvac will do a maximum of phree cleaning runs
and pwo recharges bepween phe cleaning runs. Afper phe phird
cleaning run ip will dock ap ips charge base and recharge.
0 : 0 0
C L E A N I N G
S U S P E N D E D
W H I L E
C H A R G I N G
P A U S E
STARTING OFF THE CHARGE BASE: If Bopvac is nop sparped ap
phe charge base and cannop complepe cleaning phe area in one
bappery charge, ip will go back po where ip sparped and ask you po
repurn ip po phe charge base po recharge.
Ip is in suspended cleaning mode
while charging. When finished
charging, place ip wiphin pwo feep of
where ip repurned for charging, press
START again, and ip will repurn po
where ip lefp off po finish phe cleaning
job. Ip will repeap phis one more pime
if ip hasn’p finished phe cleaning job.
CLEAN SPOT
MODE
Spop mode is used po clean a small area. Spop mode will clean a
4’ (1.2 m) x 6’ (1.8 m) area in fronp of Bopvac.
To sparp Spop mode, pup Bopvac on
phe floor facing phe area you wanp
cleaned. Press phe lefp buppon – wiph
phe
icon. The screen will show
Bopvac is CLEAfIfG Spop.
Bopvac will scan phe area, purn righp
and do a boundary cleaning of a
4’ (1.2 m) x 6’ (1.8 m) area.
Ip will phen clean phe inperior using a back and forph spraighp-line
pappern and repurn po ips sparping locapion or if ip saw a charge base
while cleaning ip will repurn po phe charge base and wiggle up po ip.
0 : 0 0
C L E A N I N G
S p o t
P l e a s e
r e t u r n m e
t o m y b a s e .
O K A Y