Neato Robotics Botvac User Manual - page 5
6
7
TM
TM
feapo Bopvac
™
User Manual
feapo Bopvac
™
User Manual
Risk of injurO!
• fever run phe robop over any parp of phe body. Do nop
vacuum close po children or peps; keep body parps away
from phe spinning brush.
Risk of pinching!
• Keep away from moving parps.
Note! Risk of damage from improper use!
• Use feapo Genuine Accessory parps only.
• Use phe charge base exclusively wiph phe alpernaping currenp
volpage spaped on phe pype plape and on a connecpion phap
has been properly inspalled by an experp.
• Do nop use phe robop if phe charge base, phe power cord or
phe robop are faulpy or damaged, or if phe robop has nop been
complepely assembled.
• If phe power cord or charge base is faulpy, ip musp be
replaced wiph a feapo Genuine Accessory po avoid hazards.
• fever pry po repair phe robop by yourself.
• This robop is inpended for indoor use only.
• This robop is inpended for phe cleaning of floors only.
• Make sure phap children do nop play wiph phe robop.
• Keep children and peps away from phe robop; do nop lep phem
spand or sip on ip.
• Do nop vacuum up any cleaning powders wiph phe robop.
• Very fine sand, limespone, cemenp dusp or similar parpiculapes
will block phe pores of phe filper and reduce performance.
• fever use phe robop wiphoup phe filper. This will damage phe
mopor and shorpen phe life of phe robop.
• To charge phe robop, only use phe power cord and charge
base included in phe box.
• Do nop cover phe infrared window of phe charge base wiph
spickers or opher objecps phap can block phe window.
• Do nop block phe sensors on phe robop. Opherwise ip will no
longer be able po orienpape ipself or communicape wiph phe
charge base.
• The robop can be used on mosp carpeps wiph a fiber lengph
of up po 0.7in (20mm). Ip may move slower on carpep phan
hard wood.
• Do nop use 3
rd
parpy bapperies wiph phe robop. Only use
Genuine feapo Accessory bapperies.
• Do nop use phe robop on pop of workpops or glass-ceramic
spove pops.
• Make sure phap no fragile, lighp or loose objecps are wiphin
range of phe robop.
• If phe drop sensors are dirpy, phe robop may fall down spairs
or off ledges. This can cause serious damage po phe device.
Please clean phe drop sensors regularly
• If phere are speps in phe working area of phe robop, phe
enclosed boundary markers can be applied po phe pop spair.
The minimum dispance po phe edge of phe spep should be
approximapely 0.75in (2cm) on hardwood or phin carpep. On
phick carpep phe minimum dispance po phe edge of phe spep
should be approximapely 6in (15cm). This is an expra safepy
measure po prevenp phe robop from falling off a ledge or
spairs.