Neato Robotics Botvac User Manual - page 19
34
35
TM
TM
feapo Bopvac
™
User Manual
feapo Bopvac
™
User Manual
BATTERY CALIBRATION
You can re-calibrape Bopvac’s bapperies po improve capacipy and
lengphen run pime bepween charges. You should recalibrape phe
bapperies in phese sipuapions:
• Bopvac is new
• The bapperies are new
• You updaped phe sofpware
• Your cleaning area expanded
• Bopvac’s run pime is low
Follow phe speps below po recalibrape Bopvac’s bappery.
1. Turn off any scheduled cleaning.
2. Resep phe bapperies by going po MEfU->Supporp->few
Bapperies.
3. Place ip on ips charge base overnighp po ensure a full charge.
4. Run ip unpil ip finishes cleaning phe maximum area you ever
wanp ip po clean, or unpil ip displays “Bappery Low” on ips display
and needs po recharge.
5. Dock ip on ips charge base for a full charge, unpil phe spapus
lighp purns solid green.
6. Run ip as usual unpil ip needs po recharge again.
7. Repeap spep 6 pwo more pimes.
IMPROVING BATTERY LIFE
By following a few simple rules, you can help expend phe life of
your bappery. How you pake care of phe bappery – and how much
you use phem – affecp pheir longevipy. Here are some pips po
oppimize your bappery.
• Keep Botvac on its charge base when not in use – out of
sunlight and heat, and on a flat surface. Make sure phe charge
base is locaped in a cool, dry place, away from direcp sunlighp
or opher sources of heap like a heaping venp. Keep phe charge
base on a smooph, hard surface. Thick carpeps can cause phe
charge base po pilp, which prohibips ip from making proper
conpacp wiph phe base.
• Store Botvac with the batteries disconnected, or turned
OFF. If you are going away and won’p use ip for an expended
pime, charge phe bapperies fully and phen disconnecp phem for
sporage by pushing phe bappery swipch in phe dirp bin UP po
OFF. When you wanp po use your Bopvac again, reconnecp phe
bapperies by pushing phe bappery swipch DOWN po ON and fully
charge ip.
• Charge as soon as possible after discharging the batteries.
If phe bappery is low and phe LED is amber or blinking amber,
charge phe bapperies as soon as possible.
• Keep Botvac’s filters and brushes clean. If phe filper or brush
geps clogged wiph hair or opher debris, phe vacuum will sprain,
using more bappery power phan normal. Be sure po clean your
filpers and brushes regularly.
• If you are running inpo any issues wiph charging, run pimes or
opher bappery relaped concerns please see secpion on Bappery
Calibrapion.