North Creek echo Assembly Manual - page 4
Capacitor Prep:
For the 20uF blue cap, attach one piece of jumper wire to each solder terminal
Resistor Prep:
With the label up, bend both leads straight down, then bend 1/4" of each end straight out (into an "L"). This method
allows the legs to function both as the connectors and as the means of suspending the resistor body above the board.
Please read the North Creek Wiring Guide, included with the kit package
Woofer Network Assembly
Closely inspect our crossover assembly diagram. This is built on a 3x4 board.
"Attach" means "slide all leads into a single ring tongue crimping section, crimp, and solder
Attach the 16" black Tef-Flex wire to one lead of the 2.74 Ohm resistor.
Attach the other end of the 2.74 Ohm resistor and one end of the 20uF Blue cap.
Attach the two remaining lead of the 20uF, the outside lead from the 2.20mH inductor, and the
16" red woofer lead in a single ring tongue.
Attach the 16" black Tef wire and the stripped end of the 16" black Lex wire with a single gold
Big Ring Jr.