North Creek echo Assembly Manual - page 6
Tweeter Network Assembly
Carefully inspect our assembled network diagram. This is a 4x5 board.
"Attach" means "slide all leads into a single ring tongue crimping section, crimp, and solder
Attach the stripped end of the 16" white wire to the gray leads of the 8uF Yellow cap with a
single ring tongue
Attach one 16" blue wire to the outside lead of the 0.56mH inductor
Attach one 16" blue wire to one lead of one of the 6.19 Ohm resistor
Attach the stripped 3" buss bar to one lead of the other 3.32 Ohm resistor
Attach the free leads of both resistors and the 16" white Tef wire with a single ring tongue.
When everything cools down, attach the resistor sub-assembly to the peg board and tighten down
the brass nuts to hold everything in place.
Attach the capacitor sub-assembly to the pegboard as indicated on our crossover diagram.
Attach the free end of the buss bar, the free end of the 0.56mH inductor, and the free lead from
the 8uF Yellow cap with a single large crimp barrel.