North Creek echo Assembly Manual - page 5
When everything cools down, drop three brass screws through the rear of the pegboard as
indicated on the assembled crossover diagram. Flip the board over and drop the ring sections
over the screws, attach with the nuts, tighten, and drop nail polish on the exposed threads.
Shoot a little silicone under the capacitor and bind it and the inductor lead to the pegboard with a
single tie wrap as shown on our diagram.
It is very important that the inductor lead is
secured under the tie wrap and in the silicone.
Shrink black shrink tube over the crimped section of the gold Big Ring Jr that holds the two
black wires.
Shrink red shrink tube over the crimped section if the gold big Ring Jr that is attached to the
2.20mH inductor.
Carefully inspect the assembly to make sure everything is exactly as our assembled crossover
diagram.