North Creek echo Assembly Manual - page 7
When everything cools down, shoot a little silicone under the capacitor and secure it and the buss
bar/capacitor/inductor connection point with a long tie wrap. Make sure the buss bar is not
touching any other connection, and coat it with silicone.
Drop the inductor into place on the pegboard, loosely secure with tie wraps, add a little silicone
under the inductor, tighten the tie wraps, trim excess
Attach the inductor-blue wire ring tongue to the pegboard
Attach the stripped ends of all three 16" blue leads with a single gold Big Ring Jr.
Heat shrink white shrink tube over the crimp section of the Big Ring Jr attached to the 16" white
lead.
Heat shrink blue shrink tube over the crimp section of the Big Ring Jr attached to the three blue
wires.
Carefully inspect the assembly to make sure everything is exactly as our assembled crossover
diagram.