Northern LED17ST User Manual - page 4
- Reorient or relocate the receiving antenna.
- Increase the space between the equipment and receiver.
- Consult the dealer, an experienced radio, or a TV technician for help.
- Only a shielded interface cable should be used.
manufacturer could void the user's authority to operate such equipment.
DOC COMPLIANCE NOTICE
This digital apparatus does not exceed the Class A limit for radio noise emissions from digital apparatus set out in the
radio interference regulation of Canadian Department of Communications.
CE COMPLIANCE
This monitor complies with the basic protection requirements of the Electromagnetic Compatibility (EMC) Directive
2004/108/EC for electrical and electronic equipment imported into the European Union (EU):
The electromagne
ized
EMC Standards for this type of apparatus. It has a level of immunity to the electromagnetic disturbance to be expected in
Connector Panel
(A)
Back View of Monitor
Connector Panel is located on the underside of the case rear
projection, just above the stand
Use ONLY a properly grounded three wire cord appropriate for the
local power system.
Power Switch can turn the monitor power off completely if it will
not be used for an extended period of time
Power Switch
(B)
HDMI
BNC 2
OUT
BNC 2
IN
BNC 1
IN
AUDIO
OUT
AUDIO
IN
AC IN
VGA
B
A