Northern Tool + Equipment NTEMP10 Owner's Manual - page 5
Step 8
Place the wheels onto each axle (valve
stems facing out) using the M12 flat
washers (4) and M12 lock nuts (4).
Tighten all nuts securely.
Turn the cart upright onto all 4 wheels.
Step 7
Attach the wheels to the cart by
first placing the wheel spacers (4)
onto the front and rear axles.
Step 9
Attach the mesh panels to
the side of the bed frame.
Each panel has a letter
stamped on it (L, R, F, B) that
corresponds to the same
letters stamped on the
bed frame itself.
Paso 8
Luego, coloque las ruedas en cada eje
(el obús hacia afuera) y por último las
arandelas planas M12 (4) y las tuercas
de fijación (4).
Apriete todas las tuercas firmemente.
Paso 7
Para fijar las ruedas al carro,
primero coloque los
espaciadores para ruedas (4) en
los ejes delantero y posterior.
Paso 9
Fije los paneles de malla en
la parte lateral del armazón
de la plataforma.
Cada panel tiene una letra
estampada (L, R, F , B) que
corresponde a las mismas
letras estampadas en el
armazón de la plataforma.
ntemp10manual.qxp 10/26/10 2:25 PM Page 9