NoSquito NT200 Operation Manual - page 10
10
OPERATIONAL INSTRUCTIONS cont’d.
Figure 15
Figure 16
Figure 17
Figure 19
Figure 18
To attach propane tank and related hoses
1. Place a full 20 lb Propane Tank on the Base with
the open side facing the Tank Retainer Clip as
shown. (Figure 15) Turn the tank until the tank
handle fits through the Tank Retainer Clip. To
secure the tank to the arm, thread the Long
Thumbscrew through the bottom hole of the
Tank Retainer Clip and opening of tank handle.
(Figure 16)
2. Attach the Gas Regulator Valve to the Propane
Tank by removing the protective plastic cap from
the threaded hose connection and attach
Regulator, turning clockwise to tighten.
(Figure 17) NOTE: The hose fitting must be
securely hand tightened to prevent gas leakage.
Check for gas leaks by wiping non-ammonia
soapy water on the connector and looking for
any signs of small bubbles forming. Inspect hose
before each use. The hose assembly must be
replaced if worn or damaged. The replacement
hose assembly is specified by and must be
purchased through Kaz Inc.
3. Secure the Hose to Assembled Support Columns
with Cord Clips. Clip power cord in outside
openings of Cord Clip. (Figure 18)
4. Place Tank Cap over Propane Tank and Regulator.
(Figure 19)