NoSquito NT200 Operation Manual - page 11
11
OPERATIONAL INSTRUCTIONS cont’d.
To Light the Burner
1. Remove the Burner Cover and following lighting
instructions located on the side of the burner.
(Figure 20)
2. Slowly turn Propane Tank on to the full open
position (turn valve counterclockwise).
3. To attach a new Propane Tank, open the side
door on the burner housing and press and hold
the GAS button for approximately two minutes
to allow air in the hose to first escape.
(Figure 21) Wait another 30 seconds for
any potential gas buildup to dissipate.
4. Depress GAS button and then press the
IGNITER button. Look through the side door
on burner housing and watch for a blue flame
while you press the IGNITER button. If the
flame does not light, you may need to press
the IGNITER button again.
5. Continue to hold the GAS button for an
additional 30 seconds after the initial ignition,
then release the GAS button. The unit should
remain lit. If it does not, wait at least 5
minutes for any built up gas to dissipate before
attempting to relight.
6. If the burner goes out - repeat steps 4 and 5.
There is a safety device that must warm up
enough to allow gas to the burner after the
GAS button is released. Check to be sure the
propane tank valve is open and that the tank
is not empty.
7. Shut the side door on the burner housing and
replace the Burner Cover as described in the
ASSEMBLY INSTRUCTIONS.
GAS
OFF
IGNITION
COOL
WEATHER
HOT
WEATHER
NOsquito Outdoor Mosquito Trap
NT200
1-800-477-0457
For lighting instructions, remove burner cover.
To shut off, close gas valve on propane tank
and switch DERMALURE to off.
DERMALURE
HO L
D
PU
SH
Figure 21
Figure 20
Control
Panel
Cover