NoSquito NT200 Operation Manual - Assembly
7
4. Attach the Burner/Control Panel/Handle/
Regulator Assembly to the Upper Support Column.
Slide the Burner/Control Panel/Handle/Regulator
Assembly onto the Upper Support Column, push
down and rotate until the alignment key drops into
the slot at the top of the Upper Support Column.
Secure with Long Thumbscrew by inserting into the
handle. (Figure 5)
5. Place Burner Cover over Burner.
Align center of cover with rain cap at top of Burner
Assembly. Push down until it snaps into place.
Cover should snap into place with minimal force.
(Figure 6)
6. Plug the Capture Head Control Cord Connector to
the underside of the Capture Head. (Figure 7)
Note: The capture Head Control Cord is intended to
be inserted in one direction. Be sure to line up the
slot properly.
7. Attach Tank Retainer Clip to bottom arm of
Assembled Support Columns with short
Thumbscrew. (Figure 8)
8. Select and place the Mosquito Trap in the
optimum location.
Refer to the following TRAP PLACEMENT section for
placement recommendations.
9. Once in place, install NOsquito Octenol Lure.
Remove lure from pouch and place in the small
cassette provided. Make certain the cassette and
lure do not touch the black DermaLure Band. Attach
to the Capture Head by hooking into the holes
located on the side. (Figure 9)
Figure 5
Figure 9
Figure 8
Figure 6
ASSEMBLY
(Continued)
ASSEMBLY
(Continued)
Figure 7
Threaded
Hole
Unthreaded
Hole