NovaSail NS-START PRO Operating Manual - Pc Mode
19
PC Mode
The PC mode is activated to exchange data between the
Bluetooth wireless transceiver and the computer. The
"NS-START Pocket V2 Wireless Manager" software allows you to check the
communication status, upgrade the embedded firmware & setup the device.
Please refer to the Novasail Wireles Manager documentation for more details; the
online manual can be open with a right click on the "NS-START.Pro Wireless
Manager" main window.
To enter in PC connectivity mode
•
With the product switched off, press first
then
simultaneously.
“PC” is displayed on the data line of the upper screen (blinking) (blinking)
with “blu” (bluetooth) shown
•
To exit the PC mode, press and hold the button
.
Troubleshooting
•
Make sure the Bluetooth connectivity is activated on the PC
•
Make sure to allow any Bluetooth device to find the PC in the operating
system
•
Close/re-open the "NS-START.Pro Wireless Manager" app. Remove the
from the previously paired bluetooth devices and
launch a new pairing process
•
Make sure the PC mode on the
is turned on: “PC”
must be blinking on the main display and “blu” (Bluetooth) must be shown
on the lower line
•
Confirm the
is indicated on the available Bluetooth
devices on the PC
•
The message ’connected’ should appear in green at the bottom of the "NS-
START.Pro Wireless Manager" window within a minute (the delay is PC
hardware dependant)
Note:
to save batteries the
will shut down
automatically if no PC connectivity is detected for 10 minutes.