Océ CS9360 Installation Manual - page 10
NOTE
If one time of head cleaning was not enough to re-
move blurred or missing parts in the check pat-
tern, perform powerful cleaning.
If those problems above were not improved after
a few times of head cleaning, refer to the follow-
ing, and perform required procedures.
Operation Manual "7 Troubleshooting"
CS9360 INSTALLATION MANUAL
AP-40810_1.0 10
1
1
1
12. If the distance between the edge of the roll media and
the pressurizing roller is less than 5 mm, follow
the procedure below to adjust the position of the
roll media.
a. Loosen the fixing levers of the right and left roll
media holders, and move the roll media to the
right or left.
b. After moving the roll media, tighten the fixing
levers.
13. Lower the media loading lever.
14. Close the front cover.
・
"User: TypeXX" (XX is a number between 1 and
30) is displayed on the operation panel.
15. Press the [+] key or [-] key to select the user type
setting.
16 Press the [Enter] key on the operation panel.
・
The user type setting is set.
・
"Media initial" is displayed on the operation panel
and media initialization starts.
・
After media initial operation is complete, "Ready to
Print" is displayed on the operation panel and the
display shifts to Normal.
17. Wind back the roll media with the scroller to remove
a media bend.
・
Media set is complete.
10 Checking printing conditions
Check the condition of the print head after the ink
replenishment.
1. Turn ON the printer and load the roll media.
10 Loading the roll media
2. Confirm that the printer functions normally.
3. Press the [<] key on the operation panel for two
seconds or more.
Nozzle check printing starts.
4. Check the sample print for blurred or missing
parts in the check pattern.
No.
Name
1
Media loading lever
NOTE
When applying pressure on the media, lower the
media loading lever further.
No.
Name
1
Media loading lever
No.
Name
1
Front cover
No.
Name
1
Roll media
No.
Name
2
Scroller
3
1
2
4
2
3
1
1
3
3
4
2
1
2
2
2
NOTE
Be sure to press the roll media holders against the
printer while locking them.
No.
Name
1
Roll media holder (Left)
2 Roll media holder (Right)
No.
Name
3
Roll media
4
Fixing levers