Océ CS9360 Installation Manual - page 9
3
1
2
4
2
3
1
1
3
3
4
1
1
2
1
2
1
5mm 5mm
5mm
5mm
2
2
2
1
1
1
1
2
1
2
1
CS9360 INSTALLATION MANUAL
9 AP-40810_1.0
1
3
2
4
1
2 4
1
1
2
1
2
2
3
1
1
2
1
2
1
2
2
29
9 Loading the roll media
This section describes how to load roll media.
Place the roll media in the center of the printer.
Follow the steps below to load roll media.
1. Loosen the fixing levers of the right and left roll
media holders, and stretch the levers wider than
the width of the roll media.
2. Tighten the left roll media holder.
3. Attach the roll media to the left roll media holder.
4. Attach the right roll media holder to the roll media
and tighten the fixing lever.
5. Loosen the fixing levers of the right and left roll
media holders, slide the roll media to the center
and tighten the levers.
6. Turn the printer ON.
・
The printer starts initial operation.
・
"Media End" is displayed on the operation panel.
7. Raise the media loading lever.
・
"Lever Up" is displayed on the operation panel.
8. Open the front cover.
9. Insert the roll media into the media feed slot.
10. Pull the roll media approximately 1 m out of the
media feed slot, which is inside the front cover.
11. While holding the front end of the roll media, wind
the media back for a short distance by turning the
flanges of the roll media holders so that the media
is not slack or slanted.
No.
Name
1
Roll media holder (Left)
No.
Name
2
Fixing lever
No.
Name
1
Roll media holder (Left)
No.
Name
2
Roll media
No.
Name
1 Roll media holder (Right)
2
Roll media
No.
Name
3
Fixing lever
No.
Name
1
Roll media holder (Left)
2 Roll media holder (Right)
No.
Name
3
Roll media
4
Fixing levers
No.
Name
1
Roll media
No.
Name
2
Media feed slot
NOTE
This procedure must be done by 2 or more persons.
If you release your grip on the roll media while it
is being wound, the media may slip off the media
feed slot and fall behind the printer.
Make sure that the right end of the roll media does
not go beyond the media loading mark. It may
affect print quality.
No.
Name
1
Roll media
No.
Name
2
Media loading mark
NOTE
When loading roll media, set each side of the media
at least 5 mm away from the edges of the pressuriz-
ing roller. Failing to do so may cause the media to
slip or wrinkle while being printed on.
No.
Name
1
Roll media
No.
Name
2
Pressurizing roller
No.
Name
1
Roll media
No.
Name
2
Pressurizing roller
No.
Name
1
Roll media
No.
Name
2
Roll media holder
NOTE
Fix the roll media holders by pressing the holders
to the printer.
No.
Name
1
Roll media holder (Left)
2 Roll media holder (Right)
No.
Name
3
Roll media
4
Fixing levers
No.
Name
1
Media loading lever
No.
Name
1
Front cover
No.
Name
1
Roll media
No.
Name
2
Media feed slot