Oce FX3000 SERIES User Manual - For Windows Nt
34
4
6
Select Océ Peer-to-Peer Network Printer, and then click Next.
7
Follow the on-screen instruction, and then click OK.
Note
Contact your administarator if you are not sure about the location and name of the printer in the network.
8
Click Finish.
Printer driver already installed
If you have already installed the printer driver and wish to configure it for network printing, follow these steps:
1
Select the printer driver you wish to configure.
2
Select File and then Properties.
3
Click the Ports tab of the driver and click Add Port.
4
Select the port that you wish to use. Typically this would be Standard TCP/IP Port. Then click the New
Port... button.
5
The Standard TCP/IP Port Wizard will start. Follow steps 8 to 12 of Printer driver not yet installed on
6
Close Add Port and Properties dialog box.
For Windows NT
®
4.0 users
Installing the TCP/IP protocol
If you did not install the TCP/IP protocol during the installation of your Windows NT
®
4.0 system (either
workstation or server) follow these steps.
1
Go to the Start button, select Settings, and then Control Panel.
2
Run the Network applet by double clicking the Network icon and then click the Protocols tab.
3
Select Add, and double click TCP/IP Protocol.
4
Insert the requested disk(s), or CD-ROM, to copy the required files.
5
Click Close. The Windows NT
®
4.0 system will review protocol bindings and then you will see the TCP/IP
Properties dialog.