Oce TCS500 Self Support Manual - Correct A Problem
What to do when a problem occurs
Correct a problem
When a problem occurs, there are two options.
■
Use the wizards. Use the on-line / off-line key (key 4 on the folded cover) on the
printer operator panel to go off-line to the wizard selection screen.
■
Use the user manual on the documentation CD-ROM for detailed descriptions about
how to correct problems.
Use the wizards to correct problems
Use the wizards to do one of the following.
■
Use the 'Feed & cut' wizard to cut the output or to clean cut a roll of media. Chapter
7 of the user manual includes complete information about how to use this wizard.
■
Use the 'Change media type' wizard to change the media type defined on the system.
‘Define the correct job settings for optimal output quality’ on page 9
■
Use the 'Optimize print quality' wizard as a final option to correct the problems with
the print quality.
‘’ on page 13
■
Use the 'Replace printhead' wizard to replace a defective printhead.
‘’ on page 15
■
Use the 'Replace cassette' wizard to replace the maintenance cassette. Chapter 10 of
the user manual includes complete information about this wizard.
■
Use the 'Configure system' wizard to check the network settings. When you do not
have a keyboard, mouse and monitor with your controller, you can also use the
'Configure system' wizard to clear the set memory. Chapter 4 of the user manual in-
cludes complete information about this wizard.
Use the user manual on the documentation CD-ROM to correct problems
When the information in this guide does not completely support you while you use the
Océ TCS500, refer to the user manual on the user documentation CD-ROM for more
information.
Chapter 1 - Self support tips (GB)
6
Correct a problem