Oce VarioPrint 1055 System Administrator Manual - Océ System Configuration
Océ System Configuration
Introduction
The Océ System Configuration application enables the remote System administrator to
configure and administer the DAC via a HTTPs connection.
Note:
The DAC needs an operational TCP/IP network connection before Océ System Con-
figuration can be used. To check the configuration, use the Key Operator System (KOS)
of the machine to print a configuration report. To configure the IP address settings of
the DAC, use the Key Operator System (KOS) of the machine. To learn how to use the
Key Operator System (KOS), see the Configuration and maintenance manual. You can
download the manual at www.oce.com.
Attention:
The remote System administrator must not change the security mode. Otherwise the
DAC is no longer in the certified configuration and is no longer able to assure the security
of its objects and itself. It is not possible to get the DAC back into the certified configu-
ration by changing the security mode back to 'High'.
Attention:
The remote System administrator must not change the 'Jobs to overwrite' settings. If E-
shredding is disabled for 'scan jobs' or 'print jobs without security code', the DAC is no
longer in the certified configuration and is no longer able to assure the security of 'scan
jobs' and 'print jobs without security code'.
Secure connection
The network HTTPs connection to the Océ System Configuration application is protected
with SSL (Secure Socket Layer).
For the purpose of configuring the DAC prior to deployment, the DAC is delivered with
a factory-default SSL certificate. A new SSL certificate should be created before the DAC
is deployed. This must be done after the hostname of the DAC is configured.
Chapter 2 - DAC Configuration
10
Océ System Configuration