Oceanic VEO 1.0 Operating Manual - page 30

30

SET TIME, information includes (Fig. 33):

>  Graphic SEt

>  Time of Day (hr:min), Hour digits flashing, with AM (or PM) 

icon if 12 Hour Format, no icon if 24 Hour Format

•  B (< 2 sec repeatedly) to step upward through Hour Set 

Points one at a time from 12: (AM) to 11: (PM), or 0: to 

23: if 24 Hour Format, in increments of 1: (hr). 

•  B (2 sec) to save the Hour Set Point and flash the Minute 

digits.

•  B (< 2 sec repeatedly) to step upward through Minute Set 

Points one at time from :00 to :59 in increments of :01 

(min). 

•  B (2 sec) to save the Time Set Point and access SN.

•  S (2 sec) to revert to Set Hour Format.

SERIAL NUMBER 

Information displayed on this screen should be recorded and 

kept with your sales receipt, it will be required in the event that 

your VEO requires factory service.

Serial Number, information includes (Fig. 34):

>  Graphic r1A (or higher), indicating the revision level of the 

firmware (VEO's operating software)

>  Graphic SN with the factory programmed serial number

Fig.34-SERIALNUMBER

Fig.33-SETTIME