Oceanic VEO 1.0 Operating Manual - page 31

31

•  B (2 sec) to step forward to Surface Main.

•  B (< 2 sec) to access Clear (Reset).

CLEAR (RESET)

The VEO is configured with a feature that allows data to be cleared, including nitrogen 

and oxygen calculations and Log entries.  This is intended for facilities using the VEO for 

rental or training activities, not for general use by individual divers.

WARNING:  Reset after a dive and subsequent use for a repetitive dive con-

ducted by the same diver could result in serious injury or death.

Upon access, a factory assigned code number is displayed with the graphics CLR and id, 

all solid (Fig. 34).

Reset procedure: 

•  B (2 sec) to start the first 2 digits (left) flashing. 

•  B (< 2 sec repeatedly) shall step upward through the first digits 

(left) one at a time.       

•  B (2 sec) shall save the first 2 digits (left) and the second 2 

digits (right) shall flash.

•  B (< 2 sec repeatedly) shall step upward through the second 

digits (right).     

•  B (2 sec) shall save the Reset Code, Clear the unit, and turn it 

Off.  

Fig.34-SERIALNUMBER