Odys DPF-Shine User Manual - page 4
ODYS DPF-Shine
EN
Remote Control
Mounting the Digital Photo Frame
Install the bracket
The included bracket is used to support the frame on any flat surface.
To install the bracket,
1) Screw off the nut from the back of the device.
2) Place the bracket onto the screw hole.
3) Return the screw to the hole and tighten it for securing the bracket.
Connect to a wall outlet via the DC adaptor
The digital photo frame is powered by 5V DC IN input. Connect the DC adaptor to the DC IN port on the back
and the electronic wall socket (see the following figure). The device should start immediately once powered.
Inserting a memory card/USB flash disk
The device provides a card slot to support memory card and a USB port for USB flash disk. Please follow these
steps to insert a memory card or USB flash disk:
(1) Find the card slot or USB port at the bottom of the machine.
(2) Insert a memory card into the slot with the face toward the back, or insert a USB flash disk into the USB port.
Open the card
slot cover
Key Function
Turn on or off the screen
SLIDE
Change transition effect of slide show
MODE
Set the aspect ratio as 4:3, 16:9 and Original
Move the cursor up / Set the brightness of the screen when
viewing photo
Move the cursor down / Open Thumbnail preview
Display the previous photo or move the cursor left
Display the next photo or move the cursor right
ENTER
Confirm a selection / Display the tool bar when viewing photo
ESC
Return
SETUP
Enter system setting mode
TIME
Display the calendar / Set the time interval between slides when
you are in slide show
ZOOM
Zoom in or zoom out the photo
ROTATE
Rotate right 90
°
Screw the nut to release or
tighten the bracket