Officezone RHIN-O-TUFF OD 3500 Instruction Book - 4000

Only qualified personal should attempt to work on this equipment.

There is not much to go wrong with the OD 4000 punch. Most of the

problems are due to setup error. There are two fuses located at the rear of the

punch that can be replaced by the customer. Here is a small troubleshooting

guide to help you through some of the problems that may be encountered.

Symptom

Machine does not cycle.

Troubleshooting

I

Possible Cause

I

Action

1) Machine is off. 1) Check power switch.

2)

 Machine not plugged in. 2)

Check both ends of power

Foot pedal not plugged

into machine.

Top Cover Switch.

Blown fuse.

Pin retainer interference.

Punch stopped in mid

cycle.

Pins 

not flush

 with pin

retainer.

cord.

3) Make sure foot pedal cable is

attached to machine.

4) Close top cover.

5) Check Fuse 1 (5A).

slot in pusher bar. (see

2) Check fuses and restart

Make sure that all the pins are

OD 

4000 

Electrical Schematic

This product has earned the UL Listing Mark and the UL Listing Mark for

Canada. E179574. The OD 4000 has been tested with a duty cycle of 20 cycles

per minute with a 2 minute rest period after 30 seconds of run time.