Officezone RHIN-O-TUFF OD 3500 Instruction Book - Wire Closer Module

Wire Closer Module

10) installation Instructions: Diagram 6

Procedure to attach the wire closer onto the OD 4000 punch

Unplug the main power cord from the OD 4000 punch.

Place the closer module on the backside of the OD 4000 punch so the closer

adjustment knobs are facing the front of the punch and are pointing up.

Attach the closer with four black knobs (I) provided with the closer module.

Use two knobs on each side to secure the unit in position.

Attach the closing handle (2) to the right side of the closer using the special

washer & screw (3) provided with the closing module. Use the allen key

provided with the closing module to secure the handle in place.

Optional wire holder

The wire holder (4) will hold a wire so the book can be placed onto the

narrow loops of the wire. It is mounted to the chip drawer located on the front

side of the OD 4000. The chip drawer should be removed for this procedure.

There are two round spacers (5) that go behind the wire holder. Mount the

wire holder with the open end facing away from the top of the chip drawer.

Now insert the screw into the hole of the wire holder, through the spacer and

turn it into the chip drawer mounting hole. Use a small screwdriver to mount

the holder to the chip drawer.

The book table / lexan guide &the top paper stop assembly should be

removed while using the wire closing module.