OHAUS Pioneer Instruction Manual - 4. Settings
Pioneer
™
EN-4
accuracy of the count. The balance automatically recalculates the Average Piece Weight when the number of parts
on the pan is less than three times the original sample size. The display shows [
APwW.OPT] each time the APW is
optimized.
3.3 Percent Mode
– Use this mode to measure the weight of a sample as a percentage of a reference weight.
To access the Percent Mode, press Unit until the display shows [
PErCEnt].
Establish a new Reference Weight - With Clear reference [
CLr.rEF] displayed, Press No to use the previously
saved Reference Weight. Press Yes to establish a new Reference Weight. Put the reference sample on the pan
and press Yes to accept or
No
t
o abort.
Percent – Place the object(s) to be compared to the reference weight on the pan.
3.4 Weigh Below Feature
Remove Weigh Below Cover
Attach wire or string to Hook
Suspend sample
4. SETTINGS
4.1 Menu Navigation
InCal*
SPAN
LINEAR**
AZSM
FILTER
A.TARE
GRAD
GBL RST
END.SET
COUNT
APWOPT
PERCENT
END.MOD
END.UNIT
GRAM
MILLIGRAM
KILOGRAM
OUNCE
NOT ALL
UNITS
SHOWN
OUT STA
A. PRINT
CONTENT
LINE FO
END.PRT
BAUD
PARITY
HAND.SH
END.R232
CAL
SETUP
MODE
RS232
END.LOCK
NO
YES
UNIT
POUND
CAL ADJ
* InCal models only
** Not available in InCal models
END.CAL
ENTER MENU
– When the balance is on, press and hold Unit/Menu until [
mMENU] appears.
Release the button and the Calibrate [
.CAL.] menu will display.
MENU NAVIGATION – Select menus, menu items and settings through use of the Yes and No buttons.
Solid arrows point to the content displayed when Yes is pressed, Dashed lines when No is pressed.
CHANGING SETTINGS – To select the displayed Setting, press Yes. To move to the next Setting, press No.
EXIT MENU – When [
.END.] is displayed, press Yes to exit the menu function, or press No to return to the Cal
menu.
Note: Press and hold No at any time to exit quickly.