Okayo UHF-PLL User Manual - page 10
HDC-707
HDC-702
CAUTION!!
Take out batteries when the devices won’t be operated in a long time.
DO NOT attempt to charge Alkaline battery. It will lead to battery
leakage or even explosion!
The performance of signal transmission is highly
involved with battery energy. Batteries with 1600
mAh (or above) in capacity are recommended.
The optional charger HDC-702 / 707 is an economy
solution for your daily use.
Frequency Pairing
1. After turning on the unit, the frequency pairing will be run once within 10 minutes.
The LED Power Indicator will be light on in blue for three times and the backlight
of LCD window will be on as well while frequency pairing successfully. While
changing to a new channel, the LED Power Indicator will be light on in blue
constantly.
2. Press “Frequency Set” key (8) for less than 2 seconds to enable frequency pairing
function again. During the process of frequency pairing, the LED Power Indicator
will be light on in blue blinkingly together with channel number blinkingly
shown on LCD window. If frequency pairing successfully, new channel number will
be shown on LCD window unblinkingly and the LED Power Indicator will be light on
in blue constantly. If frequency pairing unsuccessfully after turning-on for 20
seconds, it will back to the original channel number with LED Power Indicator light
on in blue constantly and the original channel number remained without blinking.
8
Notice: This function is available while only working with DR-501A.
Wireless Bodypack Transmitter EJ-7T+/EJ-7XT+