Okayo UHF-PLL User Manual - page 12
Operation and Setting
Turn-on / Turn-off
Setting of Channel
1. Press “Power Switch” key (7) for 1 second to turn on the unit. The LCD window will
show “On” first and then show channel number and battery life indicator after 1~2
seconds. The LED Power Indicator will be light on in blue as well.
2. Under any situation, the unit can be turned off if pressing “Power Switch” key (7)
for more than 2 seconds.
After turning on the unit, the current channel is shown on the LCD window.
Press “Frequency Set” key (3) for more than 2 seconds until the channel number
starts to blink, and then press “Up” or “Down” key (5) to select the channel
from 1-96. Press “Frequency Set” key (3) again to confirm the setting of channel
number or it will return back to the original channel number after 10 seconds without
pressing any key.
HDC-702
The performance of signal transmission is highly involved with
battery energy. Batteries with 1600 mAh (or above) in capacity
are recommended. The optional charger HDC-702 is an economy
solution for you daily use.
CAUTION!!
Take out batteries when the devices won’t be operated in a long time.
DO NOT attempt to charge Alkaline battery. It will lead to battery
leakage or even explosion!
Frequency Pairing
1. After turning on the unit, the frequency pairing will be run automatically once.
2. The LED Power Indicator will be light on blinkingly in blue for three times and
then constantly while frequency pairing successfully.
3. Press “Frequency Set” key for less than 2 seconds to enable frequency pairing
function again. If frequency pairing unsuccessfully after turning-on for 20 seconds,
it will back to the original channel number with LED Power Indicator light on in blue
constantly and the original channel number remained without blinking.
4. The distance for frequency pairing should be less than 3 meters.
10
Notice: This function is available while only working with DR-501A.
Wireless Handheld Mic EJ-701TS+/EJ-701TM+