Okayo UHF-PLL User Manual - Setup Procedure
AF OUT
LOW/HI
DC INPUT
12 15V/0.6A
AF OUT
LOW/HI
DC INPUT
12 15V/0.6A
Setup Procedure
Signal Connections
1. Connect 6.3 mm mic jack from “Unbalanced AF Output” to amplifier’s “MIC IN”
and set “impedance” at “LOW”. Or connect 6.3 mm mic jack from “unbalanced
AF Output” to amplifier’s “LINE IN” and set “impedance” at “HI”. (The same
way can be applied in EJ-701DR
-
PLUS
/
EJ-702DR
-
PLUS
.)
Amplifier
2. If using XLR mic jack, connect it from
”Balanced AF Output” to amplifier’s “AUX IN”.
In order to prevent from the impedance from being too high thus producing
unexpected noise, please set “impedance” at "LOW” if you are connecting
a mic jack to a “low input” in the subordinate device.
3
If your subordinate device is with general input socket (e.g., LINE IN, AUX IN
, etc), please set ”impedance” at “HI” to avoid too low-volume output.
AF Impedance Selection (HI / LOW Control)
Remark: AF Impedance Selection only controls
Unbalanced AF Output (6.3 mm jack).