Okayo UHF-PLL User Manual - page 9
1
2
3
4
5
6
7
8
9
10
11
1. Antenna
2. Mute Control
3. Power Switch
4. 3.5 mm push-in (EJ-7T+) or
Mini-XLR (EJ-7XT+) Microphone Input
5. LED Power Indicator
6. Sensitivity Selection
7. AUX In (3.5 mm)
8. Frequency Set
9. LCD Window
10. Turn Up / Down Frequencies Keys
11. Recharge Jack
Operation and Setting
Turn-on
Turn-off
Setting of Channel
Display of Channel
Turn on the “Power Switch” (3), the LCD window will show “On” and the Backlight
& “LED Power Indicator” (5) will be light on. After 1 second, the LCD window will
show channel number and battery life indicator.
Turn off the “Power Switch” (3), the LCD window will show “OFF” with backlight
on, and then turn off.
After turning on the unit, the current channel is shown on the LCD window.
Press “Frequency Set” key (8) for 2 seconds to until the channel number stats to
blink, and then press “Up” or “Down” key (10) to select the channel from 1-96.
Press “Frequency Set” key (8) again to confirm the setting of channel or it will return
back to the original channel number after 10 seconds without pressing “Frequency
Set” key (8).
※
The transmitter and the receiver should be set on the same channel.
Press “Up” or “Down” key (10) or press “Up” and “Down” keys (10) simultaneously to
show current frequency value on the LCD window. The LCD window will go back to
normal after releasing fingers from keys.
Wireless Bodypack Transmitter EJ-7T+/EJ-7XT+
7