Oki C9655d User Manual - Sing
Getting started > 31
C
ONNECTING
THE
NETWORK
INTERFACE
1.
Turn off the printer and the computer.
2.
Fit ferrite to an Ethernet cable as shown.
3.
Connect the Ethernet cable between the printer and an Ethernet hub.
4.
Turn on the printer and then the computer.
If your printer is to be installed as a network printer, please refer to the relevant section in
the Configuration Guide for further details on how to configure the network connection
before installing the printer drivers.
U
SING
THE
DRIVERS
DVD
Insert the Drivers DVD into your computer and follow the on-screen instructions. You are
prompted to follow a set of basic steps to configure the display panel language, install
drivers and other software and finally print a test page to check that your printer is
operating correctly thus far.
CAUTION!
Do not connect a USB cable into the network interface connector as
this may lead to malfunction.
NOTE
Administrator’s authority is required when installing a network connection.
20mm max.