P44 Chair-Mounted Stepper User Manual - page 3
Set a chair with a suitable seat
height (at least 17.5 inches from
ground) and chair leg width (so
that pole extends at least 2 inches
past outside legs) in front of P44.
Pull the pole free of P44, grasp
the front handle and gently roll
the device underneath chair seat
far enough that the pole can be
slid behind the front legs.
Slide the pole into the slot in P44,
making sure it catches behind
both front legs and extends at
least 2 inches past each leg.
Attaching to Chair
Improper
chair leg
width could
result in P44
becoming free
of chair legs.
Ensure P44 is
securely
attached via
chair pole
to front legs
before use.
3
!
CAUTION
!
CAUTION
With one hand pull the pedal arm
toward the front of P44 and hold
it while pulling the pin that se-
cures the pedal stop to the pedal
arm with the other hand.
Slide the pedal stop bar towards
the front of P44 for a starting posi-
tionrequiringlesskneeflexion
and in the opposite direction for
a starting position that requires
morekneeflexion.Thepedal
stop can also be removed from
the slot and inserted the reverse
way for a starting position requir-
ingalmostnoflexionatall.
Setting Pedal Stops
Releasing the
pedal arm
while adjusting
the pedal stop
could result in
arm springing
back.
Never induce
a knee flexion
that is painful
or uncomfort-
able.
4
!
CAUTION
!
CAUTION
Manoeuvring Around
The chair attachment pole is also
used as a handle to manoeuvre
P44 around. Insert it into the hole
in the front and lift up. The higher
you lift, the easier it is to push
P44 in a straight line. Avoid pull-
ing P44- the pole can slip out and
it is harder to manoeuvre.
!
CAUTION
Ensure the
pole is in far
enough by
pushing it
into the hole
until you meet
resistance.