PAAMON PAMCID430GT Manual - page 4
Keypad buttons instruction:
Indicating tone:
III
1)Put SIM card: please insert a valid SIM card into the card slot.
(Please make sure the power is off.)
2)Connect telephone line: connect the telephone line in your house to
the port “TEL-IN”. There's a cable in the standard kit. It could
connect your telephone set to “TEL-OUT”.
3)Connect power: use the power adaptor to connect the panel to
external power supply.
4)Turn on the backup battery: turn the power switch to “ON”
IV.Function Settings
Note: 1) All the settings are found within the setting status.
2) Press to enter/ confirm/ save, to return and to clear the
input content.
3) Press key numbers to turn up/ down/ left/ right.
.Initialization
Wire ports:
Initialization
3
4
Alarm Panel Introduction
NO COM V+ V- Z4 Z3 Z2 Z1 - + SIM TEL-IN
POWER
OFF ON
DC12V
15
14
13
12
11
10
9 8 7 6
5
4
3
2
1
out arm/ away arm
home arm
disarm: +user password+
check the alarm/ working status record.
Press to upturn or downturn.
emergency alarm.
one short beep
one short beep per second
two short beeps
two short beeps
the screen will display “AC Power Fail”
one short beep
one short beep each 3 seconds
after getting through
Keypad press
one short beep
Arm
Out arm or alarm with delay
Disarm
Telephone line error
External power failure
Battery low power
Remote call the main panel
ON/OFF
DC 12V POWER
TEL-OUT
TEL-IN
SIM
+
-
Z1
Z2
Z3
Z4
V-
V+
COM
NO
Power switch
Power adaptor port, 12V/1.2A
Connect telephone set
Connect telephone line
SIM card slot
12V output (positive. Can connect wired sensor.)
12V output (negative. Can connect wired sensor.)
Wired sensor 1 (zone number: 31)
Wired sensor 2 (zone number: 32)
Wired sensor 3 (zone number: 33)
Wired sensor 4 (zone number: 34)
Negative of siren (black cable)
Positive of siren (red cable)
Relay output. It will be closed for 3 minutes when alarm is
triggered.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
GND
NO COM V+ V- Z4 Z3 Z2 Z1 - +
2.2K
Max.AC250V/3A
DC30V/3A
Siren
PSTN line
Phone set
TEL-OUT
V+ V-
COM NC
Ω