PAAMON PAMCID430GT Manual - page 8
14.Alarm Center Setting
Enter “CMS Upload” menu, you can do all the following settings:
CMS No. Setting: this is the alarm center number (this number could
not exceed 15-digit).
User ID Setting: delete the preset numbers and input the new ID
(0001~9999). (default: 0001)
Status Upload: press to choose on/off. Turn on this function;
the operation of arm/ disarm will be uploaded to the center. System
default is off.
AC Power Fail: press to choose on/off. Turn on this function;
when the external power supply is off, the panel will send information
to the center. System default is off.
Battery Low-volt: Turn on this function; when the main panel battery
is in low power, the panel will send information to the center. System
default is off. System default is off.
Sensor Low-volt: Turn on this function; when the sensors (PIR
sensor, door contact sensor) battery low power, the panel will send
information to the center. System default is off. This version alarm
system does not have this function. Please kindly contact us if
required.
Manual test: Turn on this function; all the operations and settings of
the main panel will be uploaded to the center. System default is off.
Period Time: 00001~99999minutes 00000 means off.
11
15.User Password
This password is used to disarm the alarm system by panel keypad.
This system supports 3 user passwords (A, B, C). Password A is also
the remote call password.
Method: Enter “Password Setting” menu. Delete the previous numbers
and input the new 4-digit password. (System default: 1234) When
users use these passwords to disarm, there would be sms to
distinguish them. For example:
Disarm with password A: (XXXX) alarm system A: Armed
XXXX is the user ID (refer to the part “alarm center setting”)
16.Program Password
The program password is used to enter setting status. The default is
1234. Users can change it.
Enter “PIN Setting” menu; delete the previous numbers and input the
new 4-digit password.
17.Wireless Siren Setting
If you want wireless sirens to work together with this alarm system, you
need to set them first.
Set the wireless siren into coding status (refer to siren user manual),
and then press button on the main panel for 2 seconds. The main
panel will send wireless signal to the siren, and the siren makes two
beeps after receiving it. The setting is successful and the siren could
exit coding status.
18.Record Checking
In standby status, pressing “0” button on the panel could check the
12
User ID Setting
001
Status Upload
CMS No.Setting
075588888888
Battery Low-volt
Sensor Low-volt
AC Power Fail
Manual Test
Period Test
00000
Password Setting
****
****
****
PIN Setting
****
Function Settings
Function Settings
Off >
Off >
Off >
Off >
Off >