071114-24 neo25 5055.900 installation and operating instructions safety notice if this stove is not properly installed, a house fi re may result. For your safety, follow the installation instructions. Contact local building or fire officials about restrictions and installation inspection requirement...
2 neo25 071114-24 please save these instructions note: we strongly recommend that smoke detectors be installed. If smoke detectors have been previously installed, you may notice that they are operating more frequently. This may be due to curing of stove paint or fumes caused by accidentally leaving ...
071114-24 neo25 3 creosote formation and need for removal when wood is burned slowly, it produces tar and other organic vapours, which combine with expelled moisture to form creosote. The creosote vapours condense in the relatively cool chimney fl ue of a slow burning fi re. As a result, creosote re...
4 neo25 071114-24 caution: never use gasoline, gasoline type lantern fuel, kerosene, charcoal lighter fl uid or similar liquids to start or "freshen up" a fi re in this heater. Keep all such liquids well away from the heater while it is in use. Caution: hot while in operation. Keep children, clothin...
071114-24 neo25 5 ash removal caution: ashes are to be removed only when the heater is cold. Whenever ashes get 3(76mm) to 4(102mm) inches deep in your fi rebox, and when fi re has burned down and cooled, remove excess ashes. Leave an ash bed approximately 1" (25 mm) deep on the fi rebox bottom to h...
6 neo25 071114-24 1. Burn cord wood only, dry and well seasoned. The denser or heavier the wood when dry, the greater its heat value. This is why hardwoods are generally preferred. Green or wet wood will cause a rapid buildup of creosote. If you feel it is necessary to burn wet or unseasoned wood, d...
071114-24 neo25 7 maintenance checks check the following parts for damage such as cracks, excessive corrosion, burned out sections and excessive warping: (see website for descriptions and more detail) some warping of the baffle is normal(up to 1/4” or 6mm). Replace if the baffle has permanent warpin...
8 neo25 071114-24 40 1/8" 1.02m 41" 1.04m 29" 737mm 24 1/2" 622mm 6 1/8" 156mm neo 2.5 dimensions crate removal 1) carefully remove wood top and supports. 2) remove plastic cover. 3) using a 7/16"(12mm) wrench, remove lag bolts that secure hold down brackets to bottom pallet. 4) slide the hold down ...
071114-24 neo25 9 8" [203mm] 16" [406mm] 8" [203mm] canada only ember protection the stove may be installed on a combustible fl oor provided ember protection made from a non-combustible material with a minimum k value of 23.7 btu/ft h ˚ f is used. Equivalent to 20ga steel. This protection must exten...
10 neo25 071114-24 warning: under no circumstances is this heater to be installed in a makeshift or "temporary" manner. It may be fi red only after the following conditions have been met. * do not attempt to connect this heater to any air distribution duct. * do not connect this unit to a chimney fl...
071114-24 neo25 11 fig. #6 double wall connector - residential single wall connector - residential alcove: min. Height 7' max. Depth 3' 18" 457mm 12" 305mm 26 1/2” 673mm 20 5/8" 524mm 8" 203mm 11" 279mm 5" 127mm 15 5/8" 397mm 3" 76mm 8" 203mm 3" 76mm 8" 203mm 8" 203mm 22 1/2" 572mm 8" 203mm 11" 279m...
12 neo25 071114-24 fig. #7 chimney storm collar * 4"(102mm) diameter air inlet with rodent screen * if the crawl space is well ventilated it is not necessary to extend air inlet to outside spark arrestor rain cap radiation shield chimney connector 44" (1118 mm) minimum minimum 7' (2.1m.) ceiling hei...
071114-24 neo25 13 fig. #8 chimney * 4"(102mm) diameter air inlet with rodent screen * if the crawl space is well ventilated it is not necessary to extend air inlet to outside concrete cap chimney connector 12"(305mm) minimum fi rst section of pipe. Fireclay flue liner minimum 7' (2.1m.) ceiling hei...
14 neo25 071114-24 15 5/8" 397mm 22 1/2" 572mm 8" 203mm 11" 279mm 5" 127mm 3" 76mm 3" 76mm mobile home minimum clearance to combustibles additional requirements: warning: under no circumstances is this heater to be installed in a makeshift or "temporary" manner. It may be fi red only after the follo...
071114-24 neo25 15 optional blower the optional blower kit (wodc.Blow) is equipped with a three prong power cord and may be installed at any time. Follow installation instructions supplied with the kit. Route power supply cord away from heater. Electrical rating: 115 volts a.C., 60hz, .5 amps. Fan o...
16 neo25 071114-24 troubleshooting problem cause cure glass is dirty 1. Wood is wet - use dry wood 2. Turning down air control - do not turn down until or damper too soon a) there is a good bed of coals b) the wood is charred 3. Draft too low - improper chimney height and / or diameter - chimney plu...
071114-24 neo25 17 replacement parts - neo 2.5 (when ordering, include part number with description) item description part no. Item description part no. 2............ Embossed panel set ............................................. .............. Metallic black ................................. Ne25...
18 neo25 071114-24 operating tips 1. Always use dry, seasoned fi rewood, up to 18" long. 2. Operate on a medium to high setting, for up to 1 hour from cold start. After the initial warm up period, refuel and leave the air control on a medium setting for 5 to 10 minutes more and then set the air cont...
071114-24 neo25 19 item dimensions part number a 9” x 4 1/2” x 1 1/4” (230 mm x 115 mm x 32 mm) 5096.99 b 2 1/8” x 9” x 1 1/4” (57 mm x 230 mm x 32 mm) 7847.3 c 4 1/8" x 4 1/2” x 1 1/4” (115 mm x 115 mm x 32 mm) 7847 d 2 1/8" x 4 1/2” x 1 1/4” (57mm x 115 mm x 32 mm) 7847.1 neo 2.5 firebrick install...
20 neo25 071114-24.
071114-24 neo25 21.
22 neo25 071114-24.
071114-24 neo25 23 label a. 12 in. / 305 mm 12 in. / 305 mm b. 12 in. / 305 mm 12 in./305 mm c. 8 in. / 203 mm 8 in. / 203 mm d. 23.5 in. / 597 mm 23.5 in. / 597 mm e. 15 in. / 381 mm 15 in. / 381 mm f . 17 in. / 432 mm 17 in. / 432 mm a. 8 in. / 203 mm 8 in. / 203 mm b. 5 in. / 127 mm 5 in. / 127 m...
24 neo25 071114-24 pacific energy fireplace products ltd. 2975 allenby rd., duncan, b.C. V9l 6v8 for technical support, please contact your retailer. Web site: http://www.Pacifi cenergy.Net printed in canada.
