Model: neo 2.5 neo 2.5 important: keep these instructions for future reference. Installation and operating instructions - australia safety notice if this stove is not properly installed, a house fire may result. For your safety, follow the installation instructions. Contact local building or fire of...
Note: we strongly r e c o m m e n d t h at smoke detectors be installed. If smoke detectors have been previ- ously installed, you may notice that they are operating more frequently. This may be due to curing of stove paint or fumes caused by accidentally leaving the fire door open. Do not disconnect...
Hot glass will cause burns. Do not touch glass until cooled. Never allow children to touch glass. ! Danger 3 5055.900as_120515-20 neo 2.5 safety and maintenance 1. Burn cord wood only, dry well seasoned wood. The denser or heavier the wood when dry, the greater its heat value. This is why hardwoods ...
4 5055.900as_120515-20 neo 2.5 check the following parts for damage such as cracks, excessive corrosion, burned out sections and excessive warping**: (see website for descriptions and more detail) weekly: - firebrick - visual, for cracking. - door gasket - sagging, placement, damage. Monthly - brick...
5 5055.900as_120515-20 neo 2.5 creosote formation and need for removal when wood is burned slowly, it produces tar and other organic vapours, which combine with expelled moisture to form creosote. The creosote vapours condense in the relatively cool chimney flue of a slow burning fire. As a result, ...
1.04m 1.02m 737mm 622mm 156mm figure 1. Neo 2.5 dimensions appliance dimensions 6 5055.900as_120515-20 neo 2.5 if you suspect a chimney fire signs of a chimney fire may be one or more of the following: 1. A roaring sound. 2. Vibration of the chimney. 3. Flames and sparks shooting out of the top of t...
7 5055.900as_120515-20 neo 2.5 installation warning: under no circumstances is this heater to be installed in a makeshift or "temporary" manner. It may be fired only after the stove is installed properly. Do not attempt to connect this heater to any air distribution duct. Outside combustion air or f...
The stove may be installed on a combusti- ble floor provided ember protection made from a 9mm thick non-combustible material (bellis board) with a thermal conductivity value of .1w/m degree k. This protection must extend as follows: 300 mm on the firing side and 200mm both sides of the door opening....
Warning: install chimney and all components of chimney system according to chimney manufacturer’s instructions. Connect to a listed chimney complying with the requirements of as/nzs2918/2001 and a chimney suitable for use with solid fuel that is lined and in good condition and meets local building c...
10 5055.900as_120515-20 neo 2.5 firebrick installation c a b c d item dimensions part number a 230 mm x 115 mm x 32 mm 5096.99 b 57 mm x 230 mm x 32 mm 7847.3 c 115 mm x 115 mm x 32 mm 7847 d 57mm x 115 mm x 32 mm 7847.1 this package contains 18 full-size firebricks, as well as 6 various cut-size br...
Intake or combustion air can be supplied to the stove in one of two ways. Consult your local building codes before proceeding. 1. Outside air supply - (necessary for mobile home installation, optional for residential installation.) to draw outside air through the floor, cut or drill a 102 mm diamete...
12 5055.900as_120515-20 neo 2.5 operation caution: never use gasoline, gasoline type lantern fuel, kerosene, charcoal lighter fluid or similar liquids to start or "freshen up" a fire in this heater. Keep all such liquids well away from the heater while it is in use. Caution: hot while in operation. ...
13 5055.900as_120515-20 neo 2.5 how to test your wood add a large piece of wood to the stove when it has a good large bed of coals. It is dry if it is burning on more than one side within one minute. It is damp if it turns black and lights within three minutes. If it sizzles, hisses and blackens wit...
14 5055.900as_120515-20 neo 2.5 restarting after extended or overnight burns 1. Open door and rake hot embers towards the front of the heater. Add a couple of dry, split logs on top of embers, close door. 2. Adjust air control to high (left position) and in just a few minutes, logs should begin burn...
15 5055.900as_120515-20 neo 2.5 chimney connector pipe should be disconnected from stove to clean and inspect. Only if this is not possible should you remove baffle assembly. Caution: ceramic blanket insulation is located on top of baffle. Do not use a vacuum in this area. Do not operate with baffle...
16 5055.900as_120515-20 neo 2.5 problem cause cure glass is dirty 1. Wood is wet • use dry wood 2. Turning down air control • do not turn down until or damper too soon a) there is a good bed of coals b) the wood is charred 3. Draft too low • improper chimney height and / or diameter, -consult dealer...
17 5055.900as_120515-20 neo 2.5 2 .......Embossed panel set ............................................................. ...........Metallic black ............................................. Ne25.Pmbka ...........Blue enamel ..................................................Ne25.Ppbea ..............
18 5055.900as_120515-20 neo 2.5.
19 5055.900as_120515-20 neo 2.5 compliance plate compliance plate is located at the rear of the neo 2.5 neo 2.5 a as/nzs 4012/4013 (2014) hcmg/15/013 13/march/2015 9.9 kw 82% pivotstove.Com.Au 17/03/15 5050.425as.
? 2015 copyright pacific energy fireplace products ltd reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. Pacific energy fireplace products ltd. Web site: www.Pacificenergy.Net 2975 allenby rd., duncan, bc v9l 6v8 prin...
