050515-24 neo 1.6 insert-a 5055.750 installation and operating instructions model: neo 1.6 insert series: a safety notice if this stove is not properly installed, a house fi re may result. For your safety, follow the installation instructions. Contact local building or fi re officials about restrict...
2 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. Contents safety ............................................................................................ 3 dimensions ............................................................................................ 3 clearances ......
050515-24 neo 1.6 insert-a 3 ©pacific energy fireplace products ltd. 16” 406mm 18” 457mm 9 3/4 ” 248mm 13 1/2” 343mm 8” 203mm clearances masonry or factory built fireplace the minimum required clearances to surrounding combustible materials when installed into a masonry or factory built fi replace a...
4 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. 16” 406mm non-combustible fi replace hearth 30” 762mm 20” 508mm 8” 203mm 8” 203mm fireplace hearth requirements: (measured without the insert) the hearth can be fl ush with an adjacent combustible fl oor and must extend 16” in fron...
050515-24 neo 1.6 insert-a 5 ©pacific energy fireplace products ltd. Chimney smoke and creosote formation when wood is burned slowly, it produces tar and other or- ganic vapours, which combine with expelled moisture to form creosote. The creosote vapours condense in the relatively cool chimney fl ue...
6 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. Operation wood selection this heater is designed to burn natural wood only. Higher efficiency and lower emissions generally result when burning air-dried seasoned hardwoods, as compared to softwoods or too green or freshly cut hard...
050515-24 neo 1.6 insert-a 7 ©pacific energy fireplace products ltd. Restarting after extended or overnight burns 1) open door and rake hot embers towards the front of the heater. Add a couple of dry, split logs on top of embers, close door. 2) adjust air control to “high” position(all the way to th...
8 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. Warning: do not overtighten, tighten screws very carefully. - do not clean glass when hot - do not use abrasive cleaners on glass 6. Do not store wood within heater installation clearances, or within the space required for fuel loa...
050515-24 neo 1.6 insert-a 9 ©pacific energy fireplace products ltd. Blower replacement 1. Remove the surround front by lifting and pulling away from the unit. Remove the four screws securing the back surround to the brackets and set them aside carefully to avoid damage. 2. Remove the surround mount...
10 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. The power cord for the neo 1.6 insert comes factory set to exit the right side of the unit. If you desire, the cord can be switched to exit to the left of the unit. The cord will lose ap- proximately 12” of length when exiting the...
050515-24 neo 1.6 insert-a 11 ©pacific energy fireplace products ltd. Maintenance checks check the following parts for damage such as cracks, excessive corrosion, burned out sections and excessive warping: (see website for descriptions and more detail) weekly: - firebrick - visual, for cracking. - d...
12 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. Installation your insert is designed to be installed into an approved ma- sonry or factory built zero-clearance fi replace. The masonry fi replace must be built according to the requirements of the standard of chimneys, fireplaces...
050515-24 neo 1.6 insert-a 13 ©pacific energy fireplace products ltd. 2) feed the stainless steel liner from top of the chimney, through the damper area and into the fi replace cavity. 3) attach a stove connector to the bottom of the liner. Attach the neo 1.6 insert removable fl ue collar to the chi...
14 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. Surround assembly and installation 1) attach the surround back to the surround mounting brackets on the unit with the four screws provided.Fig. #7 2) push the entire appliance back until the surround assembly is in contact with th...
050515-24 neo 1.6 insert-a 15 ©pacific energy fireplace products ltd. Blower the insert comes equipped with variable speed circulating air blowers. The blower system is thermostatically controlled for automatic operation, as well manually with a convenient bypass switch. Blower operation automatic: ...
16 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. Troubleshooting problem cause cure excessive creosote 1) wood is too wet - use dry wood buildup 2) turning down air control - do not turn down until: too soon a) there is a good bed of coals b) the wood is charred 3) draft too low...
050515-24 neo 1.6 insert-a 17 ©pacific energy fireplace products ltd. Neo 1.6 insert firebrick installation instructions this package contains 14 full-size fi rebricks. With the heater in the upright position, install fi rebricks as follows: - first, install 4 fi rebricks against the rear wall. - ne...
18 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. 1......Top casing ......................................................................... 7834 2......Side casing, lhs ............................................................ 7841.2 3......Side casing, rhs ....................
050515-24 neo 1.6 insert-a 19 ©pacific energy fireplace products ltd. Warranty information pacifi c energy limited lifetime warranty wood products pacifi c energy extends the following warranty coverage to the original registered purchaser of the product: ltd lifetime coverage (10 years) limited lif...
20 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. F i r e - p a r t s . C o m.
050515-24 neo 1.6 insert-a 21 ©pacific energy fireplace products ltd. F i r e - p a r t s . C o m.
22 neo 1.6 insert-a 050515-24 ©pacific energy fireplace products ltd. F i r e - p a r t s . C o m.
050515-24 neo 1.6 insert-a 23 ©pacific energy fireplace products ltd. Label minimum clearance to combustibles (measured from insert door opening) dÉgagement minimum aux combustibles a) adjacent sidewall/ 381 mm / 15 in paroi latÉrale adjacente b) side facing/ 286 mm / 11.25 in revÊtement latÉral (me...
?pacific energy fireplace products ltd. Pacific energy fireplace products ltd. Phone: 1-250-748-1184 web site: http://www.Pacifi cenergy.Net 2975 allenby rd., duncan, b.C. V9l 6v8 pacific energy fireplace products ltd. Phone: 1-250-748-1184 web site: http://www.Pacifi cenergy.Net 2975 allenby rd., d...
