280514-24 super-sd1 5055.201 installation a n d o p e r at i n g instructions safety notice if this stove is not properly installed, a house fi re may result. For your safety, follow the installation instructions. Contact local building or fire officials about restrictions and installation inspectio...
2 super-sd1 280514-24 please save these instructions note: we strongly recommend that smoke detectors be installed. If smoke detectors have been previously installed, you may notice that they are operating more frequently. This may be due to curing of stove paint or fumes caused by accidentally leav...
280514-24 super-sd1 3 safety and maintenance 1. Burn wood only, dry and well seasoned. The denser or heavier the wood when dry, the greater its heat value. This is why hardwoods are generally preferred. Green or wet wood will cause a rapid buildup of creosote. If you feel it is necessary to burn wet...
4 super-sd1 280514-24 maintenance checks check the following parts for damage such as cracks, excessive corrosion, burned out sections and excessive warping: (see website for descriptions and more detail) weekly: - firebrick - visual, for cracking. - door gasket - sagging, placement, damage. Monthly...
280514-24 super-sd1 5 creosote formation and need for removal when wood is burned slowly, it produces tar and other or- ganic vapours, which combine with expelled moisture to form creosote. The creosote vapours condense in the relatively cool chimney fl ue of a slow burning fi re. As a result, creos...
6 super-sd1 280514-24 24” 610mm 24” 610mm 28” 711mm 28” 711mm 29 1/8” 740mm 29 1/8” 740mm 27 5/8” 702mm 23 5/8” 600mm 23 5/8” 600mm 23 5/8” 600mm 23 5/8” 600mm 10” 254mm 10” 254mm 10” 254mm 10” 254mm 23 7/8 606mm 23 7/8 606mm 28 3/8 721mm 27 1/2 699mm 27 1/2 699mm 29 737mm 29 737mm 27 1/2 699mm 28 1...
280514-24 super-sd1 7 22" 559mm 12" 305mm 18" 457mm 30" 762mm 25" 635mm 11" 279mm 11" 279mm 18" 457mm 4" 102mm 4" 102mm 16" 406mm 16" 406mm 28" 711mm 10" 254mm 20" 508mm 14" 357mm 26" 660mm 16" 406mm 18" 457mm 22" 559mm 28" 711mm 8" 203mm 8" 203mm 8" 203mm 5" 127mm 15" 381mm minimum clearance to com...
8 super-sd1 280514-24 fig. #2 chimney roof fl ashing storm collar * 4"(102mm) diameter air inlet with rodent screen * if the crawl space is well ventilated it is not necessary to extend air inlet to outside spark arrestor rain cap radiation shield chimney connector chimney support 56" (1422 mm) mini...
280514-24 super-sd1 9 residential installation warning: under no circumstances is this heater to be installed in a makeshift or "temporary" manner. It may be fi red only after the following conditions have been met. * do not attempt to connect this heater to any air distribution duct. * the services...
10 super-sd1 280514-24 16" [406mm] 8" [203mm] 8" [203mm] canada only floor protector the stove may be installed on a combustible fl oor provided noncombustible ember protection is used. This protection must extend as follows: in canada: 18" (457 mm) on the fi ring side and 8" (203 mm) to the other s...
280514-24 super-sd1 11 operation caution: never use gasoline, gasoline type lantern fuel, kerosene, charcoal lighter fl uid or similar liquids to start or "freshen up" a fi re in this heater. Keep all such liquids well away from the heater while it is in use. Caution: hot while in operation. Keep ch...
12 super-sd1 280514-24 ash removal caution: ashes are to be removed only when the heater is cold. Whenever ashes get 3"(76mm) to 4"(102mm) deep in your fi rebox, and when fi re has burned down and cooled, remove excess ashes. Leave an ash bed approximately 1" (25 mm) deep on the fi rebox bottom to h...
280514-24 super-sd1 13 baffle removal chimney connector pipe should be disconnected from stove to clean and inspect. Only if this is not possible should you remove baffle assembly. Do not operate with baffle assembly or insulation removed. Removal remove retaining pin at the back top of the fi rebox...
14 super-sd1 280514-24 troubleshooting problem cause cure glass is dirty 1. Wood is wet - use dry wood 2. Turning down air control - do not turn down until or damper too soon a) there is a good bed of coals b) the wood is charred 3. Draft too low - improper chimney height and / or diameter - chimney...
280514-24 super-sd1 15 replacement parts - super 27 (when ordering, include part number with description) item description part no. Item description part no. 1............ Side shield, left or right.................... Supd.4302 2............ Rear defl ector ...................................... Ss...
16 super-sd1 280514-24 2 1 6 27 20 29 8 13 11 12 24 24 25 21 9 10 7 1 19 22 31 23 3 4 28 12 11 31 18 30 5 15b 15a 16 17 16 16 14 replacement parts - spectrum and spectrum classic (when ordering, include part number with description) item description part no. Item description part no. 1............ S...
280514-24 super-sd1 17 operating tips 1. Always use dry, seasoned firewood, up to 18"*457mm) long. Load wood endwise, a mixture of large and small pieces, on top of a good ash base (1"(25mm) minimum). 2. Operate on a medium to high setting, for up to 1 hour from cold start. After the initial warm up...
18 super-sd1 280514-24 super 27 and pacifi c note: optional ash dump kit should be installed prior to pedestal or leg kit assembly. Required tools: 1 - claw hammer, 1 - 3/4" wrench, and 1- 7/16" wrench required: pedestal kit leg adapter 1 pedestal base 1 ash drawer enclosure 1 front cover (attached)...
280514-24 super-sd1 19 item/ article dimensions part number/ numÉro de piÈce a 1 1/2” x 4 1/2” x 1 1/4” (39 mm x 115 mm x 32 mm) 248.0 b 3” x 4 1/2” x 1 1/4” (77 mm x 115 mm x 32 mm) 247.0 c 4” x 4 1/2” x 1 1/4” (102 mm x 115 mm x 32 mm) 246.0 d 7 1/4” x 4 1/2” x 1 1/4” (184 mm x 115 mm x 32 mm) 245...
20 super-sd1 280514-24.
280514-24 super-sd1 21.
22 super-sd1 280514-24.
280514-24 super-sd1 23 label a. 18 in. / 455 mm 14 in. / 356 mm b. 12 in. / 305 mm 8 in. / 200 mm c. 11 in. / 280 mm 11 in. / 280 mm d. 27 in. / 685 mm 23 in. / 585 mm e. 19 in. / 485 mm 15 in. / 380 mm f. 22 in. / 560 mm 22 in. / 560 mm a. 14 in. / 356 mm 14 in. / 356 mm b. 5 in. / 127 mm 5 in. / 1...
Pacific energy fireplace products ltd. 2975 allenby rd., duncan, b.C. V9l 6v8 phone: 250-748-1184 web site: http://www.Pacifi cenergy.Net printed in canada.
