Tested and listed to can/ulc s627 and ul 1482 meets the environmental protection agency's july 1990 particulate emission standards installation & operation guide design - d models super 27 spectrum spectrum classic please save these instructions safety notice if this stove is not properly installed,...
2 super-sd1 220206-20 contents safety and maintenance ................................................................................................... 3 creosote ............................................................................................................................. 4 formati...
220206-20 super-sd1 3 please save these instructions note: we strongly recommend that smoke detectors be installed. If smoke detectors have been previously installed, you may notice that they are operating more frequently. This may be due to curing of stove paint or fumes caused by accidentally leav...
4 super-sd1 220206-20 creosote formation and need for removal when wood is burned slowly, it produces tar and other organic vapours, which combine with expelled moisture to form creo- sote. The creosote vapours condense in the relatively cool chimney flue of a slow burning fire. As a result, creosot...
220206-20 super-sd1 5 super 27 - pedestal model spectrum super 27 - leg model spectrum classic pedestal kit 1) with the unit on its back and the removable cover facing up, align the pedestal mounting holes with the holes on the stove. 2) secure in place with 1" x 1/2" bolts previously removed. 3) ca...
6 super-sd1 220206-20 22" 12" 18" 30" 25" 11" 11" 20" 16" 26" 14" 15" 5" 10" 16" 18" 28" 4" 4" 8" 28" 18" 16" 8" 22" 8" mobile home installation minimum clearance to combustibles procedure: caution: the structural integrity of the mobile home floor, wall and ceiling/roof must be maintained. Note: se...
220206-20 super-sd1 7 fig. #2 chimney roof flashing storm collar * 4" diameter air inlet with rodent screen * if the crawl space is well ventilated it is not necessary to extend air inlet to outside spark arrestor rain cap radiation shield chimney connector chimney support 56" (1422 mm) minimum mini...
8 super-sd1 220206-20 residential installation warning: under no circumstances is this heater to be installed in a makeshift or "temporary" manner. It may be fired only after the following conditions have been met. * do not attempt to connect this heater to any air distribution duct. * the services ...
220206-20 super-sd1 9 16" [406mm] 8" [203mm] 8" [203mm] canada only floor protector the stove may be installed on a combustible floor provided noncombustible ember protection is used. This protection must extend as follows: in canada: 18" (457 mm) on the firing side and 8" (203 mm) to the other side...
10 super-sd1 220206-20 operation caution: never use gasoline, gasoline type lantern fuel, kerosene, charcoal lighter fluid or similar liquids to start or "freshen up" a fire in this heater. Keep all such liquids well away from the heater while it is in use. Caution: hot while in operation. Keep chil...
220206-20 super-sd1 11 ash removal caution: ashes are to be removed only when the heater is cold. Whenever ashes get 3 to 4 inches deep in your firebox, and when fire has burned down and cooled, remove excess ashes. Leave an ash bed approximately 1" (25 mm) deep on the firebox bottom to help maintai...
12 super-sd1 220206-20 optional blower the optional blower kit (kit #wodc.Blow) is equipped with a three prong power cord and may be installed at any time. Follow installation instructions supplied with the kit. Route power supply cord away from heater. Electrical rating: 115 volts a.C.-1.02 amps. F...
220206-20 super-sd1 13 troubleshooting problem cause cure glass is dirty 1. Wood is wet - use dry wood 2. Turning down air control - do not turn down until or damper too soon a) there is a good bed of coals b) the wood is charred 3. Draft too low - improper chimney height and / or diameter - chimney...
14 super-sd1 220206-20 replacement parts - super 27 (when ordering, include part number with description) item description part no. Item description part no. 1 ............ Side shield, left or right .......................... Supd.4302 2 ............ Rear deflector ....................................
220206-20 super-sd1 15 2 1 6 27 20 29 8 13 11 12 24 26 25 21 9 10 7 1 19 22 31 23 3 4 28 12 11 31 18 30 5 14b 14c 14a 14d 14e 15b 15a 16a 17 16b 16b replacement parts - spectrum and spectrum classic (when ordering, include part number with description) item description part no. Item description part...
16 super-sd1 220206-20 understanding & operating your pacific energy stove the pacific energy super series line of woodstoves is a culmination of years of research and development. Designed to be efficient, clean-burn- ing and user-friendly, this heater will give you years of warm service. However, ...
220206-20 super-sd1 17 super 27 and pacific summit note: optional ash dump kit should be installed prior to pedestal or leg kit assembly. Required tools: 1 - claw hammer, 1 - 3/4" wrench, and 1- 7/16" wrench required: pedestal kit leg adapter 1 pedestal base 1 ash drawer enclosure 1 front cover (att...
18 super-sd1 220206-20 ash system - leg model ash system - pedestal model 1 .. Ash dump assembly 1 .. Ash dump assembly 1 .. Ash dump gasket 1 .. Ash dump gasket 1 .. Ash pan (super 27 model) 1 .. Ash pan (super 27 model) or . Ash pan (vista model) or . Ash pan (vista model) or . Ash pan (summit mod...
220206-20 super-sd1 19 certified for canada and u.S.A. Listed room heater, solid fuel type. Also for use in mobile homes tested to can/ulc s627-m93 and ul 1482-98 model series d: super 27 spectrum classic label 280801 5050.75 sup1-a2 a. Sidewall to unit 18 in. / 455 mm 14 in. / 355 mm 14 in. / 355 m...
Pacific energy fireplace products ltd. Box 1060, duncan, bc v9l 3y2 phone: 250-748-1184 web site: http://www.Pacificenergy.Net.
