Pacific Proteus 26 Operating & Maintenance Instructions - Daily Machine Maintenance
Page 13 of 17
DAILY MACHINE MAINTENANCE
CLEANING THE SQUEEGEE
To obtain the best drying results, keep the
squeegee clean.
To clean the squeegee it is
necessary to:
13) Remove the vacuum hose from the
squeegee.
14) Press release latch (1) toward the center of
the machine. Remove the squeegee
assembly.
15) Clean the inside of the squeegee thoroughly.
16) Clean the squeegee blades thoroughly.
17) Reassemble.
REPLACING THE SQUEEGEE BLADES
Check the squeegee blades for wear and if
necessary, change them.
To replace the
squeegee blades:
18) Remove the squeegee vacuum hose from its
port.
19) Press release latch toward the center of the
machine. Remove the squeegee assembly.
20) Remove the squeegee from its support.
21) Loosen the wing nuts (1) that lock the rubber
blades and take them off.
22) Replace the blades.
23) To reassemble the squeegee, repeat the
above operations in reverse.
BRUSH / PAD DRIVER REMOVAL
To remove the brushes / pad drivers:
24) Lift the brush base with the lever (1).
25) Set parking brake by pressing down on level
(2).
26) Turn the key to the OFF position.