Packard Bell EasyNote LV Quick Start Manual - page 624

28 - Stru

č

ná úvodná príru

č

ka

- Using the wireless adapter in any other environment where the risk of interference 

with other devices or services is perceived or identified as being harmful.

If you are uncertain of the policy that applies to the use of wireless adapters in a specific 

organization or environment (an airport, for example), you are encouraged to ask for 

authorization to use the adapter before you turn it on.

FCC Radio Frequency Interference Requirements (applies to device supporting 

802.11a)

This device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz and 

5.470 to 5.725 GHz frequency ranges. FCC requires this product to be used indoors for 

the frequency ranges 5.15 to 5.25 GHz and 5.470 to 5.725 GHz to reduce the potential 

for harmful interference to co-channel mobile satellite systems. High power radars are 

allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These 

radar stations can cause interference with and /or damage this device. No configuration 

controls are provided for this wireless adapter allowing any change in the frequency of 

operations outside the FCC grant of authorization for U.S operation according to Part 

15.407 of the FCC rules.

USA — Federal Communications Commission (FCC)

This device complies with Part 15 of the FCC Rules. Operation of the device is subject to 

the following two conditions:

- This device may not cause harmful interference.

- This device must accept any interference that may cause undesired operation.

-

Note:

 The radiated output power of the adapter is far below the FCC radio frequency 

exposure limits. Nevertheless, the adapter should be used in such a manner that the 

potential for human contact during normal operation is minimized. To avoid the 

possibility of exceeding the FCC radio frequency exposure limits, you should keep a 

distance of at least 20 cm between you (or any other person in the vicinity), or the 

minimum separation distance as specified by the FCC grant conditions, and the 

antenna that is built into the computer. Details of the authorized configurations can 

be found at http://www.fcc.gov/oet/ea/ by entering the FCC ID number on the device.

Interference Statement

This wireless adapter has been tested and found to comply with the limits for a Class B 

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

wireless adapter generates, uses, and can radiate radio frequency energy. If the wireless 

adapter is not installed and used in accordance with the instructions, the wireless adapter 

may cause harmful interference to radio communications. There is no guarantee, 

however, that such interference will not occur in a particular installation. If this wireless 

adapter does cause harmful interference to radio or television reception (which can be 

determined by turning the equipment off and on), the user is encouraged to try to correct 

the interference by taking one or more of the following measures:

- Reorient or relocate the receiving antenna of the equipment experiencing the 

interference.

- Increase the distance between the wireless adapter and the equipment experiencing 

the interference.

- Connect the computer with the wireless adapter to an outlet on a circuit different from 

that to which the equipment experiencing the interference is connected.

- Consult the dealer or an experienced radio/TV technician for help.

-

Note:

 The adapter must be installed and used in strict accordance with the 

manufacturer's instructions as described in the user documentation that comes with 

the product. Any other installation or use will violate FCC Part 15 regulations.