Packard Bell Smart TV32 Getting Started Manual - page 7

UK

Getting Started -  

7

E

NG

LISH

G

ETTING

 S

TARTED

I

NSTALLATION

The Packard Bell Smart TV32 provides many connection options that

should be made carefully for the best results. To make the first

connection as easy as possible, follow the 

Installation Guide (the

large sheet provided in the box) that illustrates the first connections

you should make. Other items may be connected before you start

using the Smart TV32; a set-top box (e.g. a receiver for satellite

signals) may be connected before you perform the first detection of

TV channels. However, this is not necessary and you may add a set-

top box later.

Packard Bell Smart TV32 Installation

Follow the steps described on the 

Installation Guide. This describes

how to attach the stand, connect wireless receivers for peripherals

(such as the keyboard and remote control), connect the TV aerial

and other steps that are necessary before turning on the Smart TV32.

We recommend that two people are present during installa-

tion.

Please check that you have: 

• Firmly attached the Smart TV32 stand.

• Connected the receivers (USB ‘key’ devices) for the remote con-

trol and keyboard/mouse.

• Correctly inserted batteries in the remote control, keyboard and

mouse.

• Attached the splitter cable to the TV tuners and the aerial cable.

• Connected the power cord.

• Performed the matching process for the remote control, key-

board and mouse (using the ‘connect’ button on each device, see

below.)

And optionally:

• Connected the WiPen USB device for wireless network access.

• Connected a set-top box for cable or satellite channels.

• Connected an amplifier for surround sound.

Battery Notes:

Dispose of the batteries in a designated disposal area.

Do not throw the batteries into fire. 

Do not mix battery types or combine used batteries with new

ones. 

Remove dead batteries immediately to prevent battery acid from

leaking into the battery compartment. 

If you do not intend to use the device for a long period, remove

the batteries.

Positioning the Packard Bell Smart TV32

Place the Smart TV32 on a solid surface.

• Ensure that the TV is placed in a position to allow free flow of

air. Do not cover the ventilation openings on the back cover.

• To prevent any unsafe situations, no naked flame sources, such

as candles, should be placed on or in the vicinity of the TV.

• Avoid heat, direct sunlight and exposure to rain or water. The

equipment shall not be exposed to dripping or splashing.

Matching the Remote Control, Keyboard and Mouse to 

the Packard Bell Smart TV32

When you first start the Smart TV32, it may not recognise the

remote control, keyboard or mouse (i.e. nothing happens when you

press a button). These devices must be ‘matched’ to the Smart TV32

to avoid interference with similar devices.

Two receivers are provided, one for the remote control, and another

for the keyboard and mouse.

1. Press the 

connect button on the keyboard/mouse receiver (check

that the mouse is on). 

2. Press the 

connect button on the underside of the keyboard for 3

seconds.

3. Wait 5 seconds.

4. Press the 

connect button on the underside of the mouse for 3 sec-

onds.

5. Press the 

connect button on the remote control receiver. 

6. Press the 

connect button on the remote con-

trol.

The devices should now be correctly matched. If

a device does not function, check the batteries

then repeat the matching process.

Connecting a Set-top box

If you have a set-top box (to

decode satellite, cable, ADSL or

other television signals) you

may connect it to the Smart

TV32 and add the channels to

the Smart TV32 channel list.

A set-top box should be

connected to the lower SCART

connector on the Smart TV32

(labelled 

AV IN (PC)). Make

sure the set-top box is plugged

in and on when scanning for

channels.

‘IR blaster’