PACOM PAC-VN70IIS-VFA12 Installation Manual - page 20
‐ BAD PIXEL: BAD PIXEL compensation
∙ BP DETECTION: Make the screen completely black by covering the camera.
∙ SEARCH AREA: X START/Y START/WIDTH/HEIGHT
. THRESHOLD: 40 ~ 1024
. SAVE
( Users may simply activate BP DETECTION and go directly to SAVE. Then Bad pixels in full screen are
compensated automatically)
‐ INITIAL SET : Initialize all settings of EFFECTS menu.
( TARGET CROSS and BAD PIXEL modes are not initialized)
‐ SAVE
11. SPECIAL MENU
CAM NAME
‐
Please position the arrow to point to ’CAM NAME’ by using the
UP or DOWN selection.
‐
Please select ‘ON’ by using the LEFT and RIGHT selection.
Please press the button to complete ‘ON’.
Note
If ‘OFF’ is selected, the CAM NAME does not appear on the monitor even if it has been input.
‐
Up to 15 letters are offered for the CAM NAME.
Please move the cursor to the letter to choose by using the UP
and DOWN selections.
Set an ID from A~Z /a~z /0~9 by using the UP, DOWN, LEFT
and RIGHT Selections.
Lock in the letters by using the button.
∙ When the letter is locked in, the cursor moves to the next space.
Please repeat the above to input CAM NAME.
☞ Note
∙ For a wrong name has been input,
‐ If you press the button after moving the cursor to CLR, all
letters will be erased.
‐ If you want to correct a letter, please move the cursor to the arrow at the bottom left of the
screen and press the button.
‐ Please position the cursor on the letter you wish to correct, and then move the cursor onto
the letter you wish to choose and press the button.
‐
When a name has been chosen, please select a position for the name to display.
Please move the cursor
onto
’POS’ and then press the button.
The name will appear at
the top left hand corner.
Please find the position you wish to display the name by using the 4 directional
selections, and then press the Button.
‐
Please select ‘END’ and then press the Button to complete CAM NAME input.
20 version 1.0.1