PALSON DIABOLO PLUS Operating Instructions Manual - page 17
32
33
GB
Installing/dismantling and cleaning the front wheel
1. Remove the front wheel using a tool for leverage and clean it. (See figure).
2. Fit and press the front wheel into its position to reinstall.
4.7. Cleaning the sensor and the transparent infrared window:
1. Clean the sensor and the transparent infrared window using a soft cloth.
2. The wall dirt sensor is located on the front of the robot, while the floor sensor and the transparent
infrared window are located on the bottom. (See figure below).
3. Keep the transparent window clean to ensure optimum performance.
Changing the virtual wall battery:
1. Remove the screw using a screwdriver and
open the cover.
2. Make sure the positive and negative electrodes
are correctly aligned, otherwise you could
damage the device.
3. Insert the batteries correctly.
4. Remove the battery if you do not plan to use the
device for a long period time.
5. The device uses LR20 batteries.
Changing the remote control battery:
1. Open the battery cover and change the
batteries. (See figure 1).
2. Make sure the positive and negative electrodes
are correctly aligned, otherwise you could
damage the device. (See figure 2).
3. Remove the batteries if you do not plan to use
the device for a long period time.
4. The device uses AAA batteries.
6. Remote control:
6.1. Control panel:
General view
Description of the buttons
1. “ ”
2. “ ”
3. “ ”
4. “ ”
5. “
”
6. “ ”
7. “ ”
8. “
”
9. “ ”
10. “ ”
11. “▲”
12. “▼”
13. “◄”
14. “►”
figure 1
figure 1
figure 2
figure 2
figure 3
Transmission
signal
Day display
Time/error
display
Error display
Slow clean
Fast clean
Day display
Continuous
cleaning
Start cleaning
On
Sunday, Start/Stop
Monday/UV
Tuesday/time setting
Wednesday/charge
Thursday/timer
Friday/fast cleaning
Saturday/Automatic cleaning
after full charge
All days of the week/slow
cleaning
Order confirmation
Forward
Backwards
Turn left
Turn right