PALSON DIABOLO PLUS Operating Instructions Manual - page 19
36
37
GB
Operating guide
Operating information
Turn off/Cancel/Stop
1. Press the robot on button. When the view function is in normal
mode, press this button to turn the robot on or off.
2. With the unit switched on, press this button to stop the device in
the corresponding mode.
3. When setting the programmable cleaning date and time, if the
setting is incorrect or you want to cancel it, press this button to
cancel the programmed mode and return to normal status.
4. Press and hold this button for more than 5 seconds; this will
erase the entire setting and return the unit to the default setting
OK button
After setting the configuration, press OK to save it.
FULL GO
After fully charging the battery, the machine will begin to clean
automatically on repeated occasions.
CHARGE
If you press this button when the robot is in stand-by mode or in
operation, the robot will search for the docking station to recharge
itself. When the robot stops working, it will stop recharging if you
press this button again.
▲ Forward button
By pressing "Forward", the robot will move forwards cleaning in
the direction of the arrow; press "off" to stop it. If it encounters and
obstacle, the robot will stop.
▼ Backward
By pressing and holding "Backward", the robot will move backwards
cleaning in the direction of the arrow and will stop when you release
the button.
◄Turn left button
By pressing and holding the "Turn left" button for a few seconds,
the robot will turn anticlockwise until you release the button, and
will then move forwards in the indicated direction. Press "Off" to
stop the robot. If it encounters and obstacle, the robot will stop.
►Turn right button
By pressing and holding the "Turn right" button for a few seconds,
the robot will turn clockwise until you release the button, and will
then move forwards in the indicated direction. Press "Off" to stop
the robot.
If it encounters and obstacle, the robot will stop.
1.
The remote control must be used within a radius of 10 metres, otherwise you will
not be able to operate the unit.
2.
The robotic vacuum may not locate the docking station when you press automatic
recharge if there is an obstruction, the battery is low or in more complex situations.
7. Docking station for automatic recharging
7-1 Charger display and control panel
Main view
Operating instructions
1. LED accent light
2. Accent light indicator
3. On LED
4. Charging indicator
5. Signal transmitter
6. Positive charge point
7. Negative charge point
8. DC power socket
7-2 Docking station instructions for use and operating mode
No.
Operating guide
Operating information
1
LED accent light
2
Accent light indicator Press the switch to turn the accent light on or off
3
Power LED
The power LED will turn on when the docking station is connected
to the mains, and will turn off when disconnected.
4
Charging indicator
The indicator will flash for as long as the charger is connected to
the robot.
5
Signal transmission
The signal transmission is the only way to guide the robot to the
docking station to recharge; therefore the path of the transmission
signal must be clear and free from obstructions.
6-7
Positive and negative
electrode recharge
The electrode and the robot are connected to charge upon contact,
therefore the path must be free from obstacles while in use, which
could have an impact on the recharge.
8
DC power recharging
socket
The recharging socket, or charger, is used to connect the 24V DC
outlet to the adapter and acts as the transit station for charging
between robot and adapter. The charger should be securely
attached to the wall and the adapter cable kept far away from
the charger to prevent the robot from being knocked or entangled
during cleaning.