PALSON DIABOLO PLUS Operating Instructions Manual - page 18
34
35
GB
6.2. Control panel instructions for use and operating mode
The following steps are very important: be sure not to press the wrong buttons on
the remote control!
1. You must recheck the code on the remote control or main unit when you change them after first
use or during maintenance.
2. Check that the battery in the remote control and in the main unit have sufficient charge; turn off the
main unit; press and hold OK on the remote control for more than 4 seconds and then turn on the
main unit without releasing the OK button. When you hear the robot beep twice, release the OK
button to complete the code test.
3. If you do not hear the beeps during code testing, repeat the previous steps.
Operating guide
Operating information
Start/Stop
Turn on the machine; when you press the Start/Stop button, the machine will
start working, and pressing it again will turn the machine off.
Setting the current
date and time
1. Turn on the machine.
2. When you press " ", the current time number
88
will start flashing. Use
the ▲▼ buttons to select time.
3. When you press the ◄ ► buttons, the minute indicator will start flashing.
Use ▲▼ to set the minute.
4. Then press ◄ ► to set the hour.
5. To set the day of the week, press one of the buttons SUN, MON, TUE,
WED, THU, FRI or SAT.
6. Once you have configured the setting, press OK.
7. Pressing the on button during configuration cancels the setting.
Setting cleaning time
Setting continuous
cleaning
Setting days of the week for cleaning:
1. Turn on the machine.
2. Pressing " ", SUN, MON, TUE, WED, THU, FRI or SAT will appear.
3. Press any given day of the week, several days or all days to set the device
to clean on any one, several days or every day of the week. The current
date will flash.
Setting the cleaning time:
4. Press " "; the number
88
will start flashing. Use the ▲▼ buttons to
select your desired hour of cleaning.
5. Press ◄ ►, again; the number
88
in minutes will start flashing. Use ▲▼
to set your desired minutes of cleaning.
6. Once you have configured the setting, press OK.
7. Pressing the on button during configuration cancels the setting.
Setting continuous cleaning
If you have a large house, you can use function "
" (continuous cleaning),
in which the robotic vacuum will start cleaning when fully charged and return
to the docking station automatically before its battery is flat.
1. Press "
"; the "
" indicator on the remote control LCD screen will
start flashing.
2. Once you have configured the setting, press OK.
3. The robotic vacuum will start cleaning automatically when the battery is
charged (charging time is about 5 or 6 hours).
Note: The continuous cleaning and scheduled cleaning functions
cannot be used at the same time!
Error display
If you are certain that there is an error with the device, with the remote control
within range, press this function button on the remote. The screen will show
an error code which you should be able to clear by following instructions in
the troubleshooting section.
Speed selection
Press "FAST" or "SLOW" to select either fast or slow cleaning. The machine will
automatically save your selection for future use.