Panasonic AW-PH500p Operating Instructions Manual - Connections
10
Connections
∫
When using the control panel
¥
Standard connections
O I
O I
AW-PH500
Pan/tilt head
for ENG
applications
AW-PS505
AC adapter
AW-RP301
Pan-tilt control panel
AW-PS301
AC adapter
AW-PS505
AC adapter
Lens zoom / focus cable
ENG camera
Color monitor
Zoom lens
Video camera control cable
AW-CA16U10 (10 meters)
AW-CA16U20 (20 meters)
AW-CA16U30 (30 meters)
Pan/tilt head control cable
AW-CA24U10 (10 meters)
AW-CA24U20 (20 meters)
AW-CA24U30 (30 meters)
Component signals
Video signals (5C-2V coaxial cable)
10 BaseT straight cable
(UTP category 5)
G/L signals
(5C-2V coaxial cable)
Modular joint connector
Max. distance of 500 meters (when extended) between
pan/tilt head and pan-tilt control panel (monitor, G/L source)
≥
If two to five cameras and pan/tilt heads are to be connected, use the AW-RP305 as the controller, and connect the units
through the AW-HB505 multi-port hub. For details on the connections, refer to the operating instructions of the units
concerned.
≥
The distance between the camera pan/tilt head and controller can be extended to 500 meters (maximum) using the
10 BaseT straight cable (UTP category 5).
≥
The cable for outputting the video signals from the camera pan/tilt head and the cable for inputting the G/L signals to the
pan/tilt head can be extended to 500 meters (maximum) using the 5C-2V coaxial cable.
≥
Provide the cables listed below for the connections between the camera and pan/tilt head. Make the cables long enough to
support the connections when the camera is attached to the pan/tilt head and the pan/tilt head is moved upward and
downward.
(Approx. 60 cm: This length differs depending on the camera which is attached and the positions of the camera’s
connectors.)
1
DC power cable (DC 12 V, 4-pin Cannon connector at pan/tilt head end)
2
Video output cable (composite video, BNC connector at pan/tilt head end)
3
G/L input cable (G/L signals, BNC connector at pan/tilt head end)
4
Component output cable (component signals: 9-pin D-sub connector at pan/tilt head end; used only when component
signals are to be output from a camera with component output connectors)
≥
When a motorized zoom lens is used, and its zoom/focus functions are to be controlled from the pan-tilt control panel,
select a cable which is long enough to support the connections when the pan/tilt head is moved upward and downward, as
with the cables listed above.
(Recommended cable: S14
a
7.5BMD-D24 made by Fujinon)