Panasonic AW-PH500p Operating Instructions Manual - Parts and Their Functions
6
Parts and their functions
@
POWER2 INPUT connector (4-pin Cannon)
The DC 15V power which is supplied from the AW-PS505
AC adapter is connected to this connector.
The power is supplied to the pan/tilt head’s motor only
when the MOTOR POWER SELECT switch
C
is at the
right setting. Use this connector if the camera has a high
power consumption.
A
P/T CONTROL INPUT connector (24-pin round)
The pan/tilt head control cable (AW-CA24U10, 20 or 30)
is connected to this connector.
Refer to the section entitled “Connections.”
B
CAMERA VIDEO/CONTROL IN/OUT connector
(16-pin round)
The video camera control cable is connected to this
connector.
Refer to the section entitled “Connections.”
C
MOTOR POWER SELECT switch
This switch selects the power input of the pan/tilt head’s
motor. At the left setting, the power input to the
POWER1 connector is used as the power supply of the
pan/tilt head’s motor; at the right setting, the power input
to the POWER2 connector is used.
:
COMPONENT INPUT connector (9-pin D-sub)
The component signals of the camera are input to this
connector.
1:
R GND
2:
G GND
3:
R/P
R
/C
4:
G/Y/Y
5:
B/P
B
6:
NC
7:
NC
8:
B GND
9:
NC
;
CAMERA POWER OUT connector (4-pin
Cannon)
The DC 12 V power supplied to the camera is output from
this connector.
1:
GND
4:
+12 V
VIDEO IN connector (BNC)
This connector is connected to the video signal connector
on the camera.
(1 V [p-p]/75
h
)
=
G/L OUT connector (BNC)
The G/L signals sent from the controller are output from
this connector which is connected to the G/L input
connector on the camera.
>
CAMERA CONTROL OUT connector (BNC)
This connector is connected to the control input
connector on the camera when connecting a camera
which is to be controlled using the AW-RP501 controller.
Refer to page E-11 when the AW-F575 ENG camera is to
be connected.
?
POWER1 INPUT connector (4-pin Cannon)
The DC 15V power which is supplied from the AW-PS505
AC adapter is connected to this connector.
When the MOTOR POWER SELECT switch
C
is at the
left setting, the power is supplied to both the pan/tilt head
and the camera. When it is at the right setting, the power
which is supplied from the POWER2 INPUT connector is
used as the power supply for the pan/tilt head’s motor.
4
1
3
2
1
6
2
7
3
8
4
9
5