Panasonic AW-PH500p Operating Instructions Manual - Connections
11
Connections
¥
When the AW-F575 is used as the camera to be installed
O I
O I
AW-PH500
Pan/tilt head
for ENG
applications
AW-PS505
AC adapter
AW-RP501
Hybrid control panel
AW-PS301
AC adapter
AW-PS505
AC adapter
Lens zoom / focus cable
Connecting cable between camera and pan/tilt head (
¢
¢
1)
AW-F575
AW-F575
Camera adapter
Color monitor
Zoom lens
Video camera control cable
AW-CA16U10 (10 meters)
AW-CA16U20 (20 meters)
AW-CA16U30 (30 meters)
Pan/tilt head control cable
AW-CA24U10 (10 meters)
AW-CA24U20 (20 meters)
AW-CA24U30 (30 meters)
Component signals
Video signals
Camera control signals
G/L signals
10 BaseT straight cable
(UTP category 5)
G/L signals
(5C-2V coaxial cable)
Modular joint connector
Max. distance of 500 meters (when extended) between pan/tilt head
and hybrid control panel (monitor, G/L source)
≥
If the AW-F575 camera is used, the camera can be controlled from the hybrid control panel by performing the connections
as described below.
≥
If two to five cameras and pan/tilt heads are to be connected, use the AW-RP505 as the controller, and connect the units
through the AW-HB505 multi-port hub. For details on the connections, refer to the operating instructions of the units
concerned.
∞
When multiple cameras and pan/tilt heads are to be controlled, priority is given to the switches on the camera in the
case of cameras other than the one selected by the multi-hybrid control panel.
Example: If color bar signals have been selected by the side panel switch on camera 1 and the multi-hybrid control
panel has selected the camera video signals, when camera 1 is selected by the control panel, the video
output of camera 1 will be selected as the camera video signals. However, when a camera other than
camera 1 is selected by the control panel, the video output of camera 1 will be returned to the color bar
signals. The same result will also be obtained with the other switches.
∞
The distance between the camera pan/tilt head and controller can be extended to 500 meters (maximum) using the
10 BaseT straight cable (UTP category 5).
∞
The cable for outputting the video signals from the camera pan/tilt head and the cable for inputting the G/L signals to
the pan/tilt head can be extended to 500 meters (maximum) using the 5C-2V coaxial cable.
≥
The AW-F575 camera is set to the “night eye” mode when the GAIN selector switch on the AW-RP501 hybrid control panel
or AW-RP505 multi-hybrid control panel is set to the AGC position.